Troy-Bilt 769-04090 Setting Up Your Snow Thrower, Loose Parts, Items Required For Assembly

3

Setting Up

Your Snow

Thrower

NOTE: This Operator’s Manual covers several models. Snowthrower featrues vary by model. Not all features refer- enced in this manual are applicable to all snowthrower models.

NOTE: References to right or left side of the snow thrower are deter- mined from behind the unit in the operating position.

NOTE: Replacement auger shear pins and cotter pins are provided for your convenience. Store these safely until needed.

IMPORTANT: The snow thrower is shipped with oil and WITHOUT GASOLINE. After assembly, refer to separate engine manual for proper fuel and engine oil recom- mendations.

	Loose Parts
	• The augers are secured to the auger shaft with shear
	pins and bow tie cotter pins. If you hit a foreign object
	or ice jam, the snow thrower is designed so that the
	pins may shear. Replacement shear pins and cotter
	pins are provided for your convenience. Store these
	safely until needed.
	Items Required For Assembly
	Pair of pliers	7/16” Wrenches or adjustables
	Fresh gasoline
Figure 3-1
	Assembling Handle
	• Look at the lower rear of the snow thrower frame to
	be sure the spring (found at the end of each cable) is
	attached to its actuator bracket.
	• Remove the lower handle knobs, washers and
	carriage bolts from each side of the upper handle.
	See Figure 3-2.
	• Raise the upper handle assembly until it locks over
	the lower handle. See Figure 3-1.
	• Secure the upper handle and lower handle with the
	handle knobs and carriage bolts previously removed.
Figure 3-2	• Tighten the handle knobs already in place on the
	upper holes and secure the handles firmly.

Attaching Chute Crank

• Remove the hairpin clip from the upper chute crank and slide the upper chute crank into the lower chute crank. A pair of pliers may help in this job. See Figure 3-3.

a. Align the two holes on both chute cranks. See Figure 3-3.

a b. Secure with the hairpin clip removed earlier.

b

Figure 3-3

6