Troy-Bilt STORM Series warranty Two-Stage Snow Thrower Storm Series, 10/2006

Page 1

Safety • Assembly • Operation • Adjustments • Maintenance • Troubleshooting • Parts Lists • Warranty

OPERATOR’S MANUAL

Two-Stage Snow Thrower — STORM Series

IMPORTANT

READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION

Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush- covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.

MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019	FORM NO. 769-01278D
PRINTED IN U.S.A	7/10/2006

Image 1

Contents MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio Two-Stage Snow Thrower Storm Series10/2006 Finding and Recording Model Number Table of ContentsCustomer Support Your Responsibility Chute clean-out tool is fastened to the top53% %842! #!54/ %. /0%2!4 %, 352&!#%3Your Responsibility Restrict the use PracticesYour Responsibility Do not modify enginePosition the chute assembly over the base, see Figure Setting Up Your Snow ThrowerRemove the unit from the crate or carton Tire Pressure Setting Up Your SnowKnow Your Snow Thrower Operating Your Snow ThrowerChute Assembly Clean-Out ToolAuger Control Drive Control / Auger Clutch LockGas & Oil Fill-Up Chute Clean-Out ToolElectric Starter Recoil StarterTo Engage Augers To Engage DriveAuger Control Test Chute Assembly Making AdjustmentsAuger Control Shift CableTo adjust the skid shoes Chute Bracket AdjustmentSkid Shoes Engine Maintaining Your Snow ThrowerLubrication Shave Plate Skid ShoesUnhook the support bracket spring from the frame Auger Belt ReplacementAugers Drive Belt ReplacementRemove and replace belt in the reverse order Remove the rubber ring from between the plates Friction Wheel RemovalPreparing Engine Off-Season StoragePreparing Snow Thrower Short-Term StorageThis section addresses minor service issues For further details Contact an authorized Service centerTrouble- shooting Style N To order replacement Parts, call Or visit 631-04134A Handle Assembly, Lock, RH 684-04105A Handle Assembly, Lock, LH684-04106A 710-0224 Screw, #10-16 710-04586 Screw, 1/4-20 710-123367 70 17 9 684-04154 684-04153712-0413 736-0287Page Page U.S.A Canada MANUFACTURER’S Limited Warranty for