Troy-Bilt STORM Series warranty 67 70 17 9

Page 24

Style N

26 16

						48	46
					53	61 55
			62	42	50		B
		39	62				B
40	63	39				45
						45
							7
							7
						60
				60
	59		54
49 59							47
41						57	47
41			56

51 44

52	58	23
		7

24 30

20 10

		43
69	45	2
69

67 70 68

11 4

17 9 3

Image 24

Contents Two-Stage Snow Thrower Storm Series MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio10/2006 Table of Contents Finding and Recording Model NumberCustomer Support Chute clean-out tool is fastened to the top Your Responsibility53% %842! #!54/ %. /0%2!4 %, 352&!#%3Practices Your Responsibility Restrict the useDo not modify engine Your ResponsibilitySetting Up Your Snow Thrower Position the chute assembly over the base, see FigureRemove the unit from the crate or carton Setting Up Your Snow Tire PressureOperating Your Snow Thrower Know Your Snow ThrowerClean-Out Tool Chute AssemblyAuger Control Drive Control / Auger Clutch LockChute Clean-Out Tool Gas & Oil Fill-UpElectric Starter Recoil StarterTo Engage Drive To Engage AugersAuger Control Test Making Adjustments Chute AssemblyAuger Control Shift CableChute Bracket Adjustment To adjust the skid shoesSkid Shoes Maintaining Your Snow Thrower EngineLubrication Shave Plate Skid ShoesAuger Belt Replacement Unhook the support bracket spring from the frameDrive Belt Replacement AugersRemove and replace belt in the reverse order Friction Wheel Removal Remove the rubber ring from between the platesOff-Season Storage Preparing EnginePreparing Snow Thrower Short-Term StorageFor further details Contact an authorized Service center This section addresses minor service issuesTrouble- shooting Style N To order replacement Parts, call Or visit Handle Assembly, Lock, LH 631-04134A Handle Assembly, Lock, RH 684-04105A684-04106A 710-0224 Screw, #10-16 710-04586 Screw, 1/4-20 710-123367 70 17 9 684-04153 684-04154712-0413 736-0287Page Page MANUFACTURER’S Limited Warranty for U.S.A Canada