Troy-Bilt STORM Series warranty Setting Up Your Snow, Tire Pressure

Page 7

6.Remove the flat washer and hairpin clip from the end of the chute directional control, Figure 3-5.

Insert the end of the chute directional control into the lower bracket and secure with the flat washer and hair- pin clip just removed. If necessary, the lower bracket can be adjusted. Refer to Chute Bracket Adjustment in the “Making Adjustments” section.

Tire Pressure

Before operating, check tire pressure and reduce pressure in both tires to between 15 psi and 20 psi.

NOTE: If the tire pressure is not equal in both tires, the unit may not travel in a straight path and the shave plate may wear unevenly.

3

Setting Up Your Snow

IMPORTANT: Prior to operating your snow thrower, refer to Auger Control Test in the “Operating your Snow Thrower” section. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.

Thrower

IMPORTANT: Prior to op- erating your snow thrower, refer to the Auger Control Test in the Operations section. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.

Figure 3-5

Image 7

Contents MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio Two-Stage Snow Thrower Storm Series10/2006 Finding and Recording Model Number Table of ContentsCustomer Support %, 352&!#%3 Chute clean-out tool is fastened to the topYour Responsibility 53% %842! #!54/ %. /0%2!4Your Responsibility Restrict the use PracticesYour Responsibility Do not modify enginePosition the chute assembly over the base, see Figure Setting Up Your Snow ThrowerRemove the unit from the crate or carton Tire Pressure Setting Up Your SnowKnow Your Snow Thrower Operating Your Snow ThrowerDrive Control / Auger Clutch Lock Clean-Out ToolChute Assembly Auger ControlRecoil Starter Chute Clean-Out ToolGas & Oil Fill-Up Electric StarterTo Engage Augers To Engage DriveAuger Control Test Shift Cable Making AdjustmentsChute Assembly Auger ControlTo adjust the skid shoes Chute Bracket AdjustmentSkid Shoes Shave Plate Skid Shoes Maintaining Your Snow ThrowerEngine LubricationUnhook the support bracket spring from the frame Auger Belt ReplacementAugers Drive Belt ReplacementRemove and replace belt in the reverse order Remove the rubber ring from between the plates Friction Wheel RemovalShort-Term Storage Off-Season StoragePreparing Engine Preparing Snow ThrowerThis section addresses minor service issues For further details Contact an authorized Service centerTrouble- shooting Style N To order replacement Parts, call Or visit 710-0224 Screw, #10-16 710-04586 Screw, 1/4-20 710-1233 Handle Assembly, Lock, LH631-04134A Handle Assembly, Lock, RH 684-04105A 684-04106A67 70 17 9 736-0287 684-04153684-04154 712-0413Page Page U.S.A Canada MANUFACTURER’S Limited Warranty for