Snapper 155223 STARTING, Operation Stopping, Recoil Start Models, Engine, Propelling Snow Thrower

Section 2 - OPERATING INSTRUCTIONS

2.2 STARTING, OPERATION		& STOPPING	5.	Push primer button three times to start a cold
(RECOIL START MODELS)			engine.		NOTE: Do not	use primer button to start
(Go to Page 8 for Electric		Start Models)	warm engine. See Figure			2.4.
2.2.1.	ENGINE		6.	Pull rope start handle		to crank engine.
1. Turn fuel shut off valve		to the "ON" position. See	7.	After engine starts, move the choke control to
Figure	2.3.		the	no choke "OFF" position. Allow a brief warm-up
			until engine runs smooth.
			2.2.2.		PROPELLING SNOW THROWER

TURN VALVE

TO "ON"

POSITION

FIGURE 2.3

2.Insert key into ignition switch. See Figure 2.4.

3.Move choke control to the choke, "ON" position. See Figure 2.4.

4.Move engine speed control to the "FAST" position. See Figure 2.4.

IMPORTANT: Stop the auger and wheel drive by releasing the auger and wheel drive control levers. Stop the engine by moving the engine speed control to the stop position or removing the key from the switch.

MOVE
CHOKE TO	_PUSH	PRIMER
THE"ON"	THREE	TIMES

POSITION

MOVE ENGINE

SPEED CONTROL

TO FAST

IMPORTANT: This snow thrower has four forward speeds and one reverse speed.

1.Move ground speed control to the desired speed position. See Figure 2.5.

2.Proceed to Section 2.2.3. to engage auger and

2.2.4.to engage wheel drive.

MOVE GROUND

SPEED CONTROL

GROUND	TO DESIRED
	POSITION
SPEED
CONTROL

FIGURE 2.5

INSERT KEY

FIGURE 2.4