White Outdoor 9235 warranty Setup And Adjustment

3

Setup And Adjustment

WARNING

Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.

NOTE:

				NOTE: This Operator’s Manual covers several models.
				Snow thrower features vary by model. Not all features
				discussed in this manual are applicable to all snow
	1			thrower models.
				NOTE: All references to left or right side of the snow
				thrower is from the operating position only
				Contents of Carton
			2	Carton contents are listed below with part numbers in
				parentheses.
				1. Two Ignition Keys (725-0201)
				2. 2.6 oz Bottle of 2 Cycle Oil (737-04037)
				3. Extension Cord (if so equipped) (629-0236)
				WARNING: Disconnect the spark plug
Figure 3-1				wire and ground it against the engine to
				prevent unintended starting.
				Positioning the Upper
2				Handle
				Remove packing material, if present.
				1. Making sure not to pinch the cable in the process,
				pivot the upper handle into the operating position as
				illustrated in Figure 3-1 until it clicks into place.
				2. Tighten the wing knobs to secure the handle in place
		3		as in Figure 3-1.
				Assembling the
1				Chute assembly

This Operator’s Manual covers several models. Snow thrower features vary by model. Not all features discussed in this manual are applicable to all snow thrower models.

NOTE:

All references to left or right side of the snow thrower is from the operating position only.

Figure 2

Chute Handle

For shipping reasons, the snow thrower has been packaged with the upper chute pivoted all the way down. To pivot it upward, proceed as follows:

1.Turn the chute until the chute opening is facing straight ahead. Remove the star knob and carriage bolt from the lower chute. See Figure 3-2.

2.Pivot the upper chute upward over the lip on the lower chute so that there is NO gap between the upper chute and the lower chute.

3.Resecure with the hardware just removed. If installed correctly, your snow thrower should look like Figure 3-3.

IMPORTANT: Do not use the chute handle to lift the snow thrower.

IMPORTANT: Do not use the chute handle to lift the snow thrower.

Figure 3