White Outdoor 9235 warranty Know, Your Snow Thrower

Page 7

Auger Control

Electric Starter Button

4

Know

Key

Fuel Cap

Starter Handle

Your Snow

Thrower

Chute Assembly

Primer

Spark Plug Access

Chute Handle

Choke Lever

Shave Plate

Auger

Figure 4-4

IMPORTANT: This unit runs on a mixture of fuel and oil. Do NOT operate the snow thrower without first reading the Tecumseh engine operator’s manual for instructions

Choke Lever

OFF CHOKE ON

Activating choke control closes the choke plate on carburetor and aids in starting engine. Refer to the engine manual packed with unit for more detailed instructions.

PrimerPRIMER

Depressing primer forces fuel directly into

 

 

P

M

R

 

 

 

RI E

 

engine’s carburetor to aid in cold-weather

 

 

 

 

 

starting. Refer to engine manual packed with

REMIRP

unit for more detailed instructions.

 

 

PUSH FOR A

Ignition Key

 

 

COLD ENGINE

OFF

 

 

 

 

Ignition key must be present, inserted in

 

 

 

 

Stop

 

 

 

key switch, and in the “ON” position for

 

 

 

 

ON

 

 

 

 

Run

engine to start.

IGNITION

Recoil Starter

The starter handle is used to manually start the engine.

Electric Starter Button (If so equipped) Pressing the electric starter button engages the engine’s electric starter when plugged into a 120V power source

Electric Starter Plug (If so equipped) Requires use of a two-prong outdoor extension cord (packed with the snow thrower) and a 120V power source/wall outlet.

Auger

When engaged, the augers rotation draws snow into the auger housing and throws it out the chute assembly. Rubber paddles on the augers also aid in propelling the unit as they come in contact with the pavement.

Auger Control

Located on the upper handle, the auger control is used to engage and disengage drive to the auger. Squeeze the control against the upper handle to engage auger; release it to disengage.

Chute Assembly / Chute Handle

Rotate the chute assembly to the left or right using chute handle. Pitch of the chute assembly controls angle at which the snow is thrown. Loosen wing knob on side

of the chute assembly before pivoting chute assembly upward or downward. Retighten the knob once desired position has been achieved.

Shave Plate

The shave plate maintains contact with pavement as the snow thrower is propelled, allowing snow close to pavement’s surface to be discharged.

Fuel Cap

Remove gas cap to add fuel. This unit runs on a mixture of fuel and oil. Do NOT operate the snow thrower without first reading the Tecumseh engines operator’s manual for instructions regarding proper fuel and engine oil.

regarding proper fuel and engine oil mixture.

NOTE:

This unit may

include a fuel plug, which is only used during assembly to keep dirt and debris out of fuel tank. Discard the fuel plug before filling the fuel tank.

Spark Plug Cover

NOTE: This unit may include a fuel plug, which is only

Remove spark plug cover to access spark plug.

used during assembly to keep dirt and debris out of fuel

 

tank. Discard the fuel plug before filling the fuel tank.

 

 

 

 

Image 7
Contents Model 235, S235 Single-Stage Snow Thrower05/2006 Table of Contents Your Responsibility Safety LabelsThis manual On the machine Safe OperationPractices TrainingPreparationRestrict the use Maintenance & StorageSafe Operation Practices OperationSetup And Adjustment Your Snow Thrower KnowFuel Fill-Up OperationBefore Starting Fuel And Oil MixtureClearing Snow Recoil StarterTo Stop Engine Operating the Snow ThrowerAdjustments Maintenance Do not allow Auger’s rubber paddles Replacing Auger PaddlesEngine CarburetorDrain fuel into an Do not drain Carburetor if using Fuel stabilizerPreparing Engine Preparing Snow ThrowerLog onto Or call a customer Trouble ShootingEngine runs erratic Please do not Return the unit toModel S235 Part List Snow Thrower3014 736-0400 Flat Washer .194 x .62 x 750-0589 710-1882Page Page MANUFACTURER’S Limited Warranty for