E A CE
MAINTENANCE
FILL IN DATES
AS YOU COMPLETE
REGULAR SERVICE
Check for Loose Fasteners | v' | ||
v' | |||
R Clean/Inspect | Snow Thrower | ||
O |
|
| |
WCheck / Replace V=Belts
RE Lubrication Chart
Check | Engine | Oil Level | V |
E |
|
|
|
N Change | Engine | Oil |
|
Inspect Muffler
N Check / Replace Spark Plug
E
Empty Fuel Tank
GENERAL RECOMMENDATIONS
The warranty on this snow thrower does not cover items that have been subjected to operator abuse or negligence.
To receive full value from the warranty, operator must maintain snow thrower as instructed in this manual. Some
adjustments will need to be made periodically to properly maintain your snow thrower. All adjustments in the Service
and Adjustments section of this manual should be checked at least once each season.
•Once a year, you should replace the spark plug and check belts for wear. A new spark plug will help your engine run better and last longer.
•Follow the maintenance schedule in this manual.
NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this unit. Failure to do so can cause the unit to malfunction and pose a risk of injury to the operator.
v'
V
V
v'v'
v'
LUBRiCATiON CHART
(_ SAE 5W=30 Motor Oil
(_) See "ENGINE"
in Maintenance section
(_) General
Purpose
Grease
Pivot
points
BEFORE EACH USE
1.Check engine oil level.
2.Check for loose fasteners.
3.Check controls to be sure they are functioning properly.
LUBRiCATiON
Keep your snow thrower well lubricated | ® Auger | @ |
(See "LUBRICATION CHART"). | grease fittings | Engine oil |
|
SNOW THROWER
Always observe the safety rules when performing any maintenance.
TIRES
•Maintain proper air pressure in both tires
•Keep tires free of gasoline and oil, which can harm rubber.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
BELTS
Check belts for deterioration and wear after every 50 hours of operation and replace if necessary. The belts are not adjustable. Replace belts if they begin to slip from wear. (See "TO REMOVE BELT COVER" in the Service and Adjustments section of this manual).
The belts on your snow thrower are of special construction and should be replaced by original equipment manufacturer (OEM) belts available from your nearest dealer. Using other than OEM belts can cause personal injury or damage to
15the snow thrower.