Craftsman 944.528398 owner manual Ass, Operatic, Install Discharge Chute / Chute Rotater

ASS LY / P

INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)

1.Retrieve vinyl sleeve and spring from bag of parts and retrieve the auger control rod from carton chute tray. Slide straight rod end through the small hole in the vinyl sleeve. Hook spring in hole in rod end.

2.Hook end of spring into control arm with loop opening up as shown. (See Fig. 5)

3.With top end of rod positioned under right side of control panel, push down on rod and insert end of rod into hole in auger control bracket. Secure with retainer spring.

E-OPERATIC

INSTALL DISCHARGE CHUTE / CHUTE ROTATER

HEAD (See Fig. 7)

NOTE: The multi-wrench provided in your parts bag may be used to install the chute rotater head.

1.Place discharge chute assembly on top of chute base with discharge opening toward front of snow thrower.

2.Position chute rotater head over chute bracket. If neces-

sary, rotate chute assembly to align square and pin on un- derside of chute rotater head with holes in chute bracket.

3.With chute rotater head and chute bracket aligned, position chute rotater head on pin and threaded stud of mounting bracket.

4.Install 3/8 washer and Iocknut on threaded stud and tighten securely.

AUGER

CONTROL

ROD

VINYL

SLEEVE

CONTROL

ARM

FIG. 5

AUGER CONTROL ROD AUGER CONTROL

RETAINER LEVER

SPRING\

CONTROL

BRACKET

CHUTE

ROTATER_3/8LOCKNUT

HEAD

_3/8WASHER

PIN

STUD

ROTATER HEAD

MOUNTING

BRACKET

FIG. 7

FIG. 6