SE iCE ADJ ENTS
TO REMOVE WHEELS (See Fig. 23)
Remove the klik pin and remove wheel from axle.
iMPORTANT: When installing wheel, be sure to use the axle hole closest to the end of the shaft - do not use the
hole in the wheel hub (if equipped). Inner hole in axle and hole inwheel hub are not used for your model snow thrower.
NOTE: To seal punctures or prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
KLIK PiN | (iNSTALL | OUTER HOLE |
iN OUTER | HOLE |
|
OF AXLE | ONLY) |
|
AXLE
WHEELWHEELHUB
FiG. 23
ENGINE
See engine manual.
CARBURETOR
Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 7,000 feet (2,134 meters). If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a Sears or other qualified service center.
ENGINE SPEED
Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous and will void the warranty. If you think the
TO ADJUST CABLE TENSION (See Fig. 24)
Adjust cable tension by turning the adjuster turn buckle, located on the right hand cable. Grasp the long section tightly and turn the short section to lengthen the adjuster. Adjust until cable is snug.
ADJUSTER TURN
BUCKLE
FIG, 24
19