Craftsman 944.528398 owner manual Briggs & Stratton, Cycle Engine

BRIGGS & STRATTON						4-CYCLE			ENGINE		MODEL NUMBER 20M114-1358-E2
KEY	PART									KEY	PART
NO.	NO.		DESCRIPTION							NO.	NO.		DESCRIPTION
613	794846		Screw	(Muffler)			(M6)			998	792928		Pipe-Oil
613A	794844		Screw	(Muffler)			(M8)	(Torx)		1005	794815		Fan-Flywheel
614	691620		Pin-Cotter							1022	690971	o+	Gasket-Rocker					Cover
616	795758		Crank-Governo				r			1023	698042		Cover-Rocker
621	692310		Switch-Stop							1026	695177		Rod-Push
632	695917		Spring!Link-Mechanical Governor							1029	690972		Arm-Rocker
633	690998	G	Seal-Choke/Throttle					Shaft	(Throttle	1036			Label-Emissions					(Available from
			Shaft)										a Briggs & Stratton Authorized
635	691909		Boot-Spark		Plug						277104		Dealer)
663	699854		Screw	(Control			Panel) (M5xl 0)			1058			Operator's Manual
668	794539		Spacer	(Snow			Hood)			1070	794821		Screw		(Flywheel			Fan)
668A	694257		Spacer	(Control			Bracket)			1095	795200		Gasket		Set-Valve
689	691855		Spring-Friction							1100	791959		Pivot-Rocker				Arm
697	795012		Screw	(Starter			Motor)			1119	699772		Screw		(Alternator)
718	690959		Pin-Locating			(Cylinder)				1127	695407		Screw		(Float		Bowl)
718A	695178		Pin-Locating (Cylinder Head)							1138	694255		Nut (Control Bracket) (High Speed
725	696756		Shield-Heat										Control)
727	697465		Cover-Starter			Drive				1171	794828		Stud	(Rocker			Arm Cover)
731	794540		Hood-Snow							1196	696692		Screw		(Snow Hood)
731A	793621		Hood-Snow							1210	498144		Pulley/Spring				Assembly		(Pulley)
732	699200		Screw	(Starter			Drive	Cover)		1211	498144		Pulley/Spring				Assembly		(Spring)
741	691288		Gear-Timing							1230	699847		Stud	(Control			Bracket)
742	692564		Retainer-E		Ring					1251	696762		Shield-Snow
746	694679		Gear-Idler							1251A	790471		Shield-Snow
751	794839		Washer	(Stop Wire)						1252	699480		Screw		(Snow		Shield)
773	694258		Retainer (Control Bracket)							1288	794838		Nut (Snow			Hood)
798	697890		Screw	(Rocker			Cover)			1318	698111		Knob-Snow			Hood
847	795087		Dipstick/Tube			Assembly				1329	20P414-
851	692424		Terminal-Spark				Plug				0015-E1		Replacement				Engine
868	794086	,+	Seal-Valve							1351	794847		Stud	(Cylinder Shield)
883	695398	,+	Gasket-Exhaust							1392	690800		Nut (Rewind				Guard)
892	791944		Switch-Key							1427	695757		Cap-Pipe
914	794827		Screw	(Rocker			Cover)
930	696709		Guard-Rewind
957	795027		Cap-Fuel								Engine Gasket Set				Key No. 358
957A	792647		Cap-Fuel (Fuel Fresh)
972	694260		Tank-Fuel							O	Carburetor Overhaul				Kit	Key No. 121
975	698783		Bowl-Float							+	Valve Gasket		Set	Key No. 1095
976	793382		Primer-Carburetor

Engine Power Rating Information

The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive En- gineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operat- ing conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power equipment (actual "on-site" or net power). This difference is due to a variety of factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.

Failure to do so could be hazardous, damage your snow thrower and void your warranty.

45