Install Hitch on to Tractor
1.Remove mower deck.
2.Install the bell crank (A, Figure 6) through the front holes (B) of the hitch assembly.
NOTE: Make sure that the Lift Arm connection is to the right side of the hitch assembly.
3.Place hitch on floor in front of tractor, with the hitch mounting arms towards the rear of the tractor.
4.On underside of tractor frame, insert hitch support shaft (A, Figure 7) as shown and secure, with the cotter pin (B) on inside of frame. IMPORTANT – the cotter pin must be located along the inside edge of the tractor frame.
Initial Setup & Assembly
B
A
Figure 6. Bell Crank Installation
A.Chute Rotator Drive Cover Bolt
B.Chute Rotator Drive Cover
A
B
Figure 7. Hitch Support Shaft
A.Hitch Support Shaft
B.Cotter pin
11