Briggs & Stratton 1694919 Checks Before Starting, Engine & Ground Speed Selection, Transporting

Page 6

General Operating Instructions

Checks Before Starting

1.Refer to the Maintenance & Adjustments sections of this manual and perform any needed service. Also, refer to the tractor Operator’s Manual and perform any required service.

2.Remove any objects from the work area which might interfere with plowing activity.

3.Adjust the skid shoes to desired height. See Skid Shoe Adjustment.

4.Make sure all hardware is present and secure.

Engine & Ground Speed Selection

Always run the engine at full throttle.

Set tractor speed to obtain the needed power to move the material. Operate at a safe speed, depending on conditions, so that you have complete control of the trac- tor. Rear wheel weights and chains are recommended for slippery surfaces.

WARNING

Perform the Safety System Interlock test found in your tractor Operator’s Manual. If tractor does not pass the test, do not operate the tractor. See your authorized dealer. Under no circumstances should you attempt to defeat the safety system.

Use caution when plowing a snow covered area. Snow can cover objects such as curbs, drop-offs, and other obstacles. Be familiar with the area you are plowing.

To prevent an explosion or fire, never store the tractor with fuel in the tank inside a building where an ignition source is present.

IMPORTANT NOTE

To prevent damage to the unit, always raise the dozer blade BEFORE turning or backing up.

A rear weight carrier is recommended for additional trac- tion.

Transporting

For maximum ground clearance, transport the blade to and from work areas fully raised and angled straight ahead.

Starting & Stopping

1.Start the tractor engine. Set engine throttle to full.

2.Raise the attachment lift and travel to the work site.

3.Set the angling control to the desired angle.

4.Lower the attachment lift and begin plowing.

5.Raise the plow before backing up.

6.To stop the tractor, set ground speed to neutral and set the parking brake. Before leaving the seat, stop the engine, set the parking brake, remove the key, and wait for all moving parts to stop.

DANGER

OPERATING ON SLOPES CAN BE DANGEROUS

Never operate on slopes greater than 17.6% (10°) which is a rise of 3-1/2 feet (106cm) vertically in 10 feet (607cm) horizontally.

Operate the unit at a slow ground speed when driving onto slope. Avoid using brakes to control ground speed.

When operating on slopes that are greater than 15 % (8.5°) but less than 17.6%, use additional wheel weights or counterweights.

In addition to counterweights, use extra caution when operating on slopes. Drive UP and DOWN the slope, never across the face, use caution when changing directions and DO NOT START OR STOP ON SLOPE.

For additional traction, tire chains and a weight box can be added. Maximum weight added to tractor should not exceed 35 lbs. per wheel and 100 additional lbs. in weight box.

4

Image 6
Contents OPERATOR’S Manual Page Table of Contents Safety Rules Information General WarningsBlade Angle Control Lever Attachment LiftTransporting Checks Before StartingEngine & Ground Speed Selection Starting & StoppingDaily Storage Changing Angle of the BladeSnow Plowing Tips Off-Season StoragePage Maintenance Schedule For Normal Care General LubricationTroubleshooting Adjustments, & Service Troubleshooting WarningSkid Shoe Adjustment Lift AdjustmentInitial Setup Assembly Qty DescriptionInstall Hitch on to Tractor Bell Crank Installation Chute Rotator Drive Cover BoltInitial Setup & Assembly Install Snow Blade Lift Arm Attaching Pivot Assembly to Snow Blade Attaching Snow Blade to TractorTravel Height Adjustment Attaching Snow Blade Contort Arm to TractorRemoval Snow Blade RemovalRemoval O D U C T S