Briggs & Stratton 1694919 Attaching Pivot Assembly to Snow Blade, Attaching Snow Blade to Tractor

Page 16

Initial Setup & Assembly

Attaching Pivot Assembly to Snow Blade

1.Attach the pivot assembly (A, Figure 11) to the snow blade (C) using bolt and nut (B).

2.Attach the tension spring (D) to the pivot assembly

(A) and then to the eyebolt (E).

3.Tighten the eyebolt nut (F) to apply tension to the spring. Tighten lock nut (G) when the proper spring tension is set.

Attaching Snow Blade to Tractor

1.Position snow blade assembly in front of tractor.

2.Remove the mounting pin (A, Figure 12) and quick clip (B) from the snow blade.

NOTE: Make sure that the bell crank (C) is rotated for- ward before installing the snow blade assembly.

3.Align mounting holes on snow blade frame with the mounting holes in the hitch.

4.Insert mounting pin (A) and secure with hair pin (B).

	D
E	B
E
F	A
	H
G	I
G	B
C

Figure 11. Snow Blade Assembly

A.Pivot Assembly

B.Whiz Lock Nut

C.Snow Blade Assembly

D.Tension Spring

E.Eyebolt

F.Nut

G.Capscrew

H.Flat Washer

I.Spacer

	A
C	B
C

Figure 12. Attaching Snow Blade to Hitch

A.Mounting Pin

B.Hair Pin

C.Bell Crank

14

Image 16

Contents OPERATOR’S Manual Page Table of Contents Safety Rules Information General WarningsBlade Angle Control Lever Attachment LiftChecks Before Starting Engine & Ground Speed SelectionTransporting Starting & StoppingChanging Angle of the Blade Snow Plowing TipsDaily Storage Off-Season StoragePage Maintenance Schedule For Normal Care General LubricationTroubleshooting Adjustments, & Service Troubleshooting WarningSkid Shoe Adjustment Lift AdjustmentInitial Setup Assembly Qty DescriptionInstall Hitch on to Tractor Bell Crank Installation Chute Rotator Drive Cover BoltInitial Setup & Assembly Install Snow Blade Lift Arm Attaching Pivot Assembly to Snow Blade Attaching Snow Blade to TractorTravel Height Adjustment Attaching Snow Blade Contort Arm to TractorRemoval Snow Blade RemovalRemoval O D U C T S