Cub Cadet 928 SWE, 945 SWE warranty Service, Belt Removal Preparation, Auger Belt Replacement

Page 19

Service

Belt Replacement

Belt Removal Preparation

1.Disconnect the chute crank assembly at the discharge chute end by removing the hairpin clip and the flat washer. Refer to Figure 7-1.

Figure 7-1

2.Removethehexscrewsandlocknutssecuringtheforward end of the support tubes to the back of the auger housing, and pivot the tubes upward.

3.Removetheplasticbeltcoveronthefrontoftheengineby removing the three self-tapping screws. See Figure 7-2.

Figure 7-2

4.Loosen the bolt shown in Figure 7-3 securing the belt keeper bracket and remove the other bolt. Push the belt keeper bracket up off the engine pulley. Refer to

Figure 7-3.

Remove

Loosen

Figure 7-3

Auger Belt Replacement

To remove and replace your snow thrower’s auger belt, proceed as follows:

1.Remove the hairpin clip and flat washer from the ferrule in order to disconnect the auger idler rod from the brake bracket assembly. See Figure 7-4.

NOTE: Make sure to maintain the location of the ferrule on the idler rod.

Figure 7-4

Image 19

Contents Operator’s Manual Record Product Information Table of ContentsTo The Owner Thank YouCalifornia Proposition Training Important Safe Operation PracticesPreparation Safe Handling of Gasoline OperationDo not modify engine Maintenance & StorageSpark Arrestor Symbol Safety SymbolsContents of Carton Assembly & Set-UpAssembly Chute Directional Control Chute AssemblySet-Up AdjustmentsAdjusting Drive and Auger Controls Testing Drive Control & Shift LeverGas & Oil Fill-Up Ignition Key Controls and FeaturesShift Lever Choke ControlOil Fill Electric Starter SwitchChute Assembly Primer BulbWheel Steering Controls Chute Clean-Out ToolTwo-Way Chute Control Chute Directional ControlElectric Starter OperationStarting The Engine Stopping The EngineOperating Tips Replacing Shear PinsTo Engage Drive To Engage AugersMaintenance Maintenance & AdjustmentsLubrication Gear Case Tire Pressure Auger ControlBelt Removal Preparation ServiceBelt Replacement Auger Belt ReplacementPulley Slot Changing Friction Wheel Drive Belt ReplacementService Short-Term Storage Off-Season StorageLong-Term Storage Problem Cause Remedy TroubleshootingComponent Replacement PartsPage Page CUB Cadet LLC MANUFACTURER’S Limited Warranty for