SECTION 7: TROUBLESHOOTING
Problem |
| Cause |
| Remedy |
|
|
|
|
|
Engine fails to start | 1. | Fuel tank empty, or stale fuel. | 1. | Fill tank with clean, fresh gasoline. Fuel |
|
|
|
| becomes stale after thirty days. |
| 2. | Blocked fuel line. | 2. | Clean the fuel line. |
| 3. | Choke not in the ON position | 3. | Move switch to the ON position |
| 4. | Faulty spark plug. | 4. | Clean, adjust gap or replace. |
| 5. | Safety key not in ignition switch on engine. | 5. | Insert the key fully into the switch. |
| 6. | Spark plug wire disconnected. | 6. | Connect spark plug wire. |
| 7. | Primer button not being used properly. | 7. | Refer to the engine manual. |
Engine runs erratic | 1. | Unit running on CHOKE. | 1. | Move the choke lever to OFF position. |
| 2. | Blocked fuel line or stale fuel. | 2. | Clean the fuel line; fill the tank with clean, |
|
|
|
| fresh gasoline. |
| 3. | Water or dirt in the fuel system. | 3. | Drain the fuel tank and carburetor. Refill with |
|
|
|
| fresh fuel. |
Loss of power | 1. | Spark plug wire loose. | 1. | Connect and tighten spark plug wire. |
| 2. | Gas cap vent hole plugged. | 2. | Remove ice and snow from gas cap. Be |
|
|
|
| certain vent hole is clear. |
Excessive vibration | 1. | Loose parts or damaged auger. | 1. | Stop the engine immediately and disconnect |
|
|
|
| the spark plug wire. Tighten all bolts and nuts. |
|
|
|
| If vibration continues, have the unit serviced |
|
|
|
| by an authorized Cub Cadet service dealer. |
Unit fails | 1. | Drive control cable in need of adjustment. | 1. | Adjust drive control cable. Refer to Making |
to propel itself |
|
|
| Adjustment Section. |
| 2. | Drive belt loose or damaged. | 2. | Replace drive belt. Refer to the Service |
|
|
|
| Section. |
Unit fails | 1. | Chute assembly clogged. | 1. | Stop engine and disconnect spark plug wire. |
to discharge snow |
|
|
| Clean chute and inside of auger housing with |
|
|
|
| |
| 2. | Shear pin(s) sheared. | 2. | Replace shear pin(s). |
| 3. | Foreign object lodged in auger. | 3. | Stop engine immediately and disconnect |
|
|
|
| spark plug wire. Remove object from auger |
|
|
|
| with |
| 4. | Auger control cable in need of adjustment. | 4. | Adjust auger control cable. Refer to the |
|
|
|
| Making Adjustments Section. |
| 5. | Auger belt loose or damaged. | 5. | Refer to Service Section. |
17