STEP 11: (SEE FIGURE 11)
•Find the cable clip that is attached to the left side of the tractor frame underneath the footrest. Open the clip and remove the mower clutch cable. Do not remove the clip from the tractor frame. The cable reattaches to the clip when using the mower deck.
•Move the attachment clutch lever on the dash panel to the disengaged position.
•Place the clutch/idler assembly on the floor on the left side of the tractor.
•Attach the tractor's mower clutch cable to the cable bracket on the clutch/idler assembly. Secure the cable housing guide (groove down) to the cable bracket using the original collar and a 5/64" hair cotter pin ( JJ).
•Place a spacer (RR) on the welded pin on the idler arm. Hook the end of the clutch cable spring over the pin and secure it with a 1/4" washer (T) and a 5/64" hair cotter pin (JJ).
•Align cable bracket with welded pin and tighten the nut assembled in step 9.
5/64" HAIR |
COTTER PIN (JJ) |
1/4" WASHER (T) |
SPACER (RR) |
5/64" HAIR |
COTTER PIN (JJ) |
TRACTOR'S |
CLUTCH CABLE |
CABLE |
BRACKET |
FIGURE 11
ATTACH CLUTCH IDLER ASSEMBLY TO TRACTOR
STEP 12: (SEE FIGURE 12)
•Attach the clutch/idler assembly to the tractor frame.
Hook the notched suspension arms onto the two shoulder bolts (Q) assembled to the outside of the tractor frame. Lift the front of the assembly and attach it to the R.H. and L.H. hanger brackets using two pivot lock pins (MM) and 1/8" hairpin cotters (KK).
•Loosely attach the mower clutch cable to the left side of the tractor frame with a nylon tie (OO). Do not pull the nylon tie completely tight. The cable may need to be removed from the nylon tie when using the mower deck.
PIVOT LOCK PIN (MM) | 1/8" HAIRPIN | NYLON TIE (OO) | |
(use this hole) | COTTER (KK) |
| |
L.H. HANGER | SHOULDER | ||
BRACKET | BOLT (Q) | ||
| MOWER |
|
|
| CLUTCH |
|
|
| CABLE |
|
|
FIGURE 12 | VIEWED FROM LEFT SIDE | ||
STEP 13: (SEE FIGURE 13)
•Assemble the drive belt onto the engine pulley first and then onto the large pulley on top of the clutch/ idler assembly. The belt must be placed inside the engine pulley belt keeper(s) and between the large pulley and the keeper bolt next to it.
IMPORTANT: Do Not assemble the "V" belt outside of the engine pulley keepers or outside of the keeper bolt next to the large pulley.
•Go to step 48 on page 21.
ENGINE |
| ENGINE | |
PULLEY | ENGINE | PULLEY | |
KEEPER | KEEPER | ||
PULLEY | |||
|
|
Left Side
of Tractor
IDLER |
|
PULLEY | KEEPER BOLT |
|
FIGURE 13 | VIEWED FROM UNDERNEATH |
10