STEP 18: (SEE FIGURE 17)
•Turn the clutch/idler assembly right side up.
•Slightly loosen the hex bolt next to the flat idler pulley. Install the drive belt down between the hex bolt and the flat idler pulley with the flat side of the belt against the pulley. Retighten the hex bolt.
•Loop the belt around the large
HEX BOLTS | FLAT IDLER |
| PULLEY |
DRIVE BELT |
|
FIGURE 17
Did you choose the correct drive belt for STOP your tractor? Using the wrong length belt
may cause premature bearing or belt failure.
STEP 19: (SEE FIGURE 18)
•Attach the clutch/idler assembly to the tractor frame.
Hook the notched suspension arms onto the two shoulder bolts (Q) assembled to the outside of the tractor frame. Lift the front of the assembly and attach it to the R.H. and L.H. hanger brackets using two pivot lock pins (MM) and 1/8" hairpin cotters (KK).
PIVOT LOCK PIN (MM) | L.H. HANGER | SHOULDER | |
(use second hole) | BRACKET | ||
BOLT (Q) | |||
|
| ||
| 1/8" HAIRPIN |
| |
| COTTER (KK) |
| |
FIGURE 18 | VIEWED FROM LEFT SIDE | ||
STEP 20: (SEE FIGURE 19)
•Assemble the drive belt onto the engine pulley first and then onto the large pulley on top of the clutch/ idler assembly. Place the belt to the inside of the idler pulley and the belt keeper bolt located beside the large pulley.
•Place tension on the belt by pulling the left side tensioning chain (PP) out as far as the 3/32" hairpin cotter in the chain will allow. Secure the chain in this position by inserting a 1/8" hairpin cotter (KK) through the chain.
IMPORTANT: Do Not assemble the drive belt around the outside of the keeper bolt beside the large pulley.
•Go to step 48 on page 21.
CLUTCH/IDLER ASSEMBLY
ENGINE |
|
PULLEY | 1/8" HAIRPIN |
| |
| COTTER (KK) |
IDLER PULLEY 
CHAIN (PP)
(L.H. SIDE)
KEEPER BOLT
FIGURE 19 | VIEWED FROM UNDERNEATH |
12