STEP 45: (SEE FIGURE 44)
•Turn the clutch/idler assembly right side up.
•Slightly loosen the hex bolt next to the flat idler pulley. Install the drive belt down between the hex bolt and the flat idler pulley with the flat side of the belt against the pulley. Retighten the hex bolt.
•Loop the belt around the large
HEX BOLTS | FLAT IDLER |
| PULLEY |
DRIVE BELT |
|
FIGURE 44
Did you choose the correct drive belt for STOP your tractor? Using the wrong length belt
may cause premature bearing or belt failure.
STEP 46: (SEE FIGURE 45)
•Attach the clutch/idler assembly to the tractor frame as follows. Hook the assembly's notched arms onto the two shoulder bolts you assembled to the inside of the tractor frame. Lift the front of the assembly and attach it to the R.H. and L.H. hanger brackets using two pivot lock pins (MM) and 1/8" hairpin cotters (KK).
1/8" HAIRPIN COTTER (KK) | |
| PIVOT LOCK PIN (MM) |
| (use second hole) |
FIGURE 45 | RIGHT SIDE VIEW |
STEP 47: (SEE FIGURE 46)
•Assemble the drive belt onto the engine pulley and then onto the large pulley on top of the clutch/idler assembly. The belt must be placed to the inside of the idler pulley and the keeper bolt located beside the large pulley.
•Place tension on the belt by pulling the left side tensioning chain out as far as the 3/32" hairpin cotter
(LL)will allow. Secure the chain in this position by inserting a 1/8" hairpin cotter (KK) through the chain.
IMPORTANT: Do Not assemble the "V" belt around the outside of the engine pulley keeper or the keeper bolt.
CLUTCH/IDLER ASSEMBLY
ENGINE |
|
PULLEY | 1/8" HAIRPIN |
| |
| COTTER (KK) |
IDLER PULLEY 
CHAIN (PP)
(L.H. SIDE)
KEEPER BOLT
FIGURE 46 | VIEWED FROM UNDERNEATH |
20