THIS SECTION IS FOR TRACTORS WITH A MANUAL ATTACHMENT CLUTCH
If your tractor has an electric attachment clutch go to step 14 on page 11.
STEP 7: (SEE FIGURE 7)
•Attach the pulley (long end of hub facing down) and the large spacer (SS) to the hole shown in the clutch/ idler assembly. Use a 3/8" x
3/8" HEX LOCK NUT (DD) | 3/8" |
3/8" LOCKWASHER (S) | WASHER (X) |
| |
PULLEY (TT) | LONG END |
| |
LARGE SPACER (SS) | OF HUB |
| 3/8" X |
| HEX BOLT |
| (B) |
FIGURE 7
STEP 8: (SEE FIGURE 8)
•Attach the two suspension arms to the rear of the clutch/idler assembly using two 5/16" x 3/4" hex bolts
(E) and 5/16" nylock nuts (CC) for each arm. Place the arms on the outside of the frame with the notches to the rear.
•Insert a tensioning chain through the hole shown and attach the end link to the spring on the lower idler arm.
5/16" NYLOCK |
|
NUT (CC) |
|
5/16" x 3/4" |
|
HEX BOLT (E) | TENSIONING CHAIN (PP) |
FIGURE 8
STEP 9: (SEE FIGURE 9)
•Attach the cable bracket to the slot shown in the clutch/idler assembly using a 5/16" x 3/4" carriage bolt (O) and a 5/16" nylock nut (CC). Place the bolt in the front hole of the bracket and in the end of the slot closest to the pulley. Do not tighten yet.
5/16" x 3/4" |
CARRIAGE BOLT (O) |
CABLE |
BRACKET |
5/16" NYLOCK |
NUT (CC) |
FIGURE 9
STEP 10: (SEE FIGURE 10)
•Two different length drive belts are included with your snow thrower. Tractors with manual attachment clutches and single front deck suspension brackets use the 56" drive belt with #48138 printed on the outside of the belt. DO NOT USE the other belt.
•Slightly loosen the hex bolt next to the flat idler pulley. Install the drive belt down between the hex bolt and the flat idler pulley with the flat side of the belt against the pulley. Retighten the hex bolt.
•Loop the belt around the large
HEX BOLTS | FLAT IDLER |
| |
| PULLEYS |
(#48138) |
|
DRIVE BELT |
|
FIGURE 10
Did you select the correct drive belt for your STOP tractor? Using the wrong length belt may
cause premature bearing or belt failure.
9