_IL snow thrower indoors or in
ARNING: Never store your an enclosed, poorly venti-
lated area. If gasoline remains in the tank, fumes may reach an open flame, spark or pilot light from a fur- nace, water heater, clothes dryer, cigarette, etc.
NOTE: To prevent engine damage (if snow thrower is not used for more than
30 days) follow the steps below.
SNOW THROWER
1.Thoroughly clean the snow thrower.
2.Lubricate all lubrication points. See the Maintenance section.
3.Be sure that all nuts, bolts and screws are securely fastened. In- spect all visible moving parts for damage, breakage and wear. Re- place if necessary.
4.Touch up all rusted or chipped paint surfaces; sand lightly before paint- ing.
5.Cover the bare metal parts of the blower housing auger and the im- peller with rust preventative, such as a spray lubricant.
NOTE: A yearly checkup or
ensuring that your snow thrower will provide maximum performance for the next season.
ENGINE
line outdoors, away from
_IL ARNING: Drain the gaso- fire or flame.
Gasoline must be removed or treated to
prevent gum deposits from forming in the fuel tank, filter, hose, and carburetor during storage. Also, during storage al- cohol blended gasoline that uses etha- nol or methanol (sometimes called gasohol) attracts water. It acts on the gasoline to form acids which damage the engine.
1.To remove gasoline, run the engine until the fuel tank is empty and the engine stops.
2.If you do not remove the gasoline, use fuel stabilizer supplied with unit
or purchase Craftsman Fuel Stabi- lizer No. 3550. Add fuel stabilizer to
any gasoline left in the tank to mini- mize gum deposits and acids. It the fuel tank is almost empty, mix stabi-
lizer with fresh gasoline in a sepa- rate container and add some to the
fuel tank.
3.Always follow the instruction on the stabilizer container. After the stabi-
lizer is added to the fuel tank, run the engine at least ten minutes to allow the mixture to reach the car- buretor.
4, Change the engine oil.
5.Lubricate the piston/cylinder area. First, remove the spark plug and squid a few drops of clean engine oil into the spark plug hole. Next, cover the spark plug hole with a rag to absorb oil spray. Then, pull two or three times on the recoil starter rope to rotate the engine. Finally, install the spark plug and attach the spark plug wire.
OTHER
1.If possible, store your snow thrower indoors and cover it to give protec- tion from dust and dirt.
2, If the machine must be stored out- doors, block up the snow thrower to be sure the entire machine is off the ground.
3.Cover the snow thrower with a suit- able protective cover that does not retain moisture. Do not use plastic.
IMPORTANT: Never cover snow
thrower while engine and exhaust areas are still warm.