Craftsman 536.8852 operating instructions General Recommendations, Product Specifications

Page 2

WARRANTY STATEMENT

2

STORAGE

23

SAFETY RULES

3

TROUBLE SHOOTING CHART..

24

INTERNATIONAL SYMBOLS ....

5

REPAIR

PARTS

26

ASSEMBLY

7

ENGINE

REPAIR PARTS

32

OPERATION

9

SPANISH

(ESPANOL)

38

MAINTENANCE

15

PARTS ORDERING/SERVICE ..

 

SERVICE AND ADJUSTMENT ..

18

 

BACK COVER

LIMITED ONE-YEAR WARRANTY ON CRAFTSMAN SNOW THROWER

For one years from the date of purchase, when this Craftsman Snow thrower is maintained, lubricated, and tuned up according to the operating and maintenance instructions in the owner's manual, Sears will repair, free of charge, any defect in material or workmanship.

If this Craftsman Snow thrower is used for commercial or rental purposes, this warranty ap- plies for only 90 days from the date of purchase.

This warranty does not cover the following:

Items which become worn during normal use, such as spark plugs, drive belts and shear pins.

Repair necessary because of operator abuse or negligence, including bent crankshafts and the failure to maintain the equipment according to the instructions contained in the owner's manual.

WARRANTY SERVICE IS AVAILABLE BY RETURNING THE CRAFTSMAN SNOW

THROWER TO THE NEAREST SEARS SERVICE CENTER/DEPARTMENT IN THE UNITE D STATES. THIS WARRANTY APPLIES ON LY WHILE THIS PRODUCT IS IN USE IN THE UNITED STATES.

This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.

Sears, Roebuck and Co., D817WA, Hoffman Estates. IL 60179

GENERAL RECOMMENDATIONS

The warranty on this snow thrower does not cover items that have been sub-

jected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain the snow thrower as instructed in this manual. Some adjustments will need to be made

periodically to properly maintain your snow thrower.

All adjustments in the Service and Ad-

justments section of this manual must be checked at least once each season.

PRODUCT SPECIFICATIONS

Horse Power:

3,8

 

Displacement:

10 cu, in.

 

Fuel Tank:

1 quart

 

Spark P ug:

Champion0,030Gap

RJ19LM

F-OO1072M

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Snow Thrower General Recommendations Product SpecificationsHorse Power Displacement 10 cu, Fuel Tank Quart Spark P ug Training Maintenance and Storage Let++ IIo A-q Contents of Parts Bag actual size Tools RequiredChecklist ZAIildDischarge Chute Changes thedirecdon the snowisthrown Know Your Snow ThrowerAuger Drive Lever Starts and stops the auger Choke Control Used to start a coldTo Stop Your Snow Thrower HOW to Move ForwardHOW to Throw Snow To Control Snow DischargeFill GAS Fill OILDipstick. do not overfill. See Figure Before Starting the Engine HOW to Start the EngineHOW to Stop the Engine Cold StartSnow Throwing Tips Warm StartFrozen Starter Whenever possible, discharge the snow down windSnow Banks and Drifts DRY and Average SnowWET Packed Snow After Each USE Lubrication ChartCustomer Responsibilities Remove the screws a and nuts B from the belt cover HOW to Remove the TOP CoverHOW to Remove the Belt Cover AFigure10Spark Plug HOW to Change the Engine OILNot Overfill HOW to Adjust Auger Drive Cable No tension on the idler armHOW to Adjust Theaugerbrake Turn the adjuster nut SeeHOW to Remove Auger Drive Belt Auger Housing HOW to Remove the AugerTo install the auger, reverse the above steps To adjust To Adjust the CarburetorTo Adjust or Replace the Spark Plug Snow Thrower OtherDifficult starting CorrectionTroublecause Water or dirt in fuelsystemFOO1072M25
Top Page Image Contents