Craftsman 536.8852 HOW to Remove the TOP Cover, HOW to Remove the Belt Cover, AFigure10

Page 16

HOW TO REMOVE THE TOP COVER

There are no adjustments under the top cover. If removal is required, follow the steps below.

1.Remove screws A that attach the md support clamp the the top cov- er. Pivot crank assembly rod up and lay on unit.

2.Remove locking screw B.

3.Remove attachment screws C from lower rear edge.

4.Slide the top cover approximately 3/8 inch toward the gas tank and lift up.

5.To install the top cover, reverse the above steps.

HOW TO REMOVE THE BELT COVER

1.Remove the screws A and nuts B from the belt cover.

2.Remove attachment screw C from the rear of the belt cover.

3.Remove the belt cover from the unit.

BI

B

A

B

C

Top Cover

C

Crank _ssembly

Rod

Figure 9

4.To install the belt cover, reverse the above steps.

NOTE: The belt cover has belt guides moulded onto the inside of the cover.

When you install the belt cover, engage the auger drive lever to tighten the belt against the pulley. This will provide ade- quate clearance for the belt guides when installing the belt cover.

C

/

Belt Cover

A\

AA

AFigure10

F_)01072M16

Image 16

Contents Snow Thrower Horse Power Displacement 10 cu, Fuel Tank Quart Spark P ug Product SpecificationsGeneral Recommendations Training Maintenance and Storage Let++ IIo A-q Contents of Parts Bag actual size Tools RequiredChecklist ZAIildKnow Your Snow Thrower Auger Drive Lever Starts and stops the augerDischarge Chute Changes thedirecdon the snowisthrown Choke Control Used to start a coldHOW to Move Forward HOW to Throw SnowTo Stop Your Snow Thrower To Control Snow DischargeDipstick. do not overfill. See Figure Fill OILFill GAS HOW to Start the Engine HOW to Stop the EngineBefore Starting the Engine Cold StartWarm Start Frozen StarterSnow Throwing Tips Whenever possible, discharge the snow down windWET Packed Snow DRY and Average SnowSnow Banks and Drifts Customer Responsibilities Lubrication ChartAfter Each USE HOW to Remove the TOP Cover HOW to Remove the Belt CoverRemove the screws a and nuts B from the belt cover AFigure10Not Overfill HOW to Change the Engine OILSpark Plug HOW to Adjust Auger Drive Cable No tension on the idler armHOW to Adjust Theaugerbrake Turn the adjuster nut SeeHOW to Remove Auger Drive Belt To install the auger, reverse the above steps HOW to Remove the AugerAuger Housing To Adjust or Replace the Spark Plug To Adjust the CarburetorTo adjust Snow Thrower OtherCorrection TroublecauseDifficult starting Water or dirt in fuelsystemFOO1072M25