Craftsman 536,884,791 manual Parts packed separately in carton not shown full size

Page 5

Parts packed separately in carton (not shown full size)

2 - Ignition Keys

(Attached to engine in plastic bag)

1 - Crank Assembly

1 - Snow Chute Assembly

,4k

CAUTION: Always wear safety glasses or eye shields while assembling snow thrower.

TOOLS REQUIRED FOR ASSEMBLY

1- Knife (to cut carton and plastic ties) 2- 1/2 inch wrenches (or adjustable

wrenches)

2- 9/16 inch wrenches (or adjustable wrenches)

2- 3/4 inch wrenches (or adjustable wrenches)

1 - Pliers (to spread cotter pin)

1 - Measuring tape or ruler

The figure below shows the snow thrower in the shipping position.

The figure to the right shows the snow thrower completely assembled.

Lower I ]andle

Clutch

Cable

Reference to the right or left hand side

of the snow thrower is from the operator's position behind the unit.

TO REMOVE SNOW THROWER

FROM CARTON

•Locate all parts packed separately (as

shown above) and remove from carton. NOTE: Place fuel stabilizer in a safe place until needed for storage.

Auger drive lever

Crank

Assembly

Chute

Deflector

Upper

Assembly

Image 5

Contents SEARS, Roebuck and CO., Hoffman Estates, IL 60179 U.S.A Snow ThrowerCalifornia Proposition Limited TWO-YEAR Warranty on Craftsman Snow ThrowerDisengage the auger/impeller, stop engine, and remove key OperationSpare Spacers 16 In. Hsx Nuts Shear Pins Maintenance and StorageTo Remove Snow Thrower From Carton Tools Required for AssemblyParts packed separately in carton not shown full size 16 Hex Head Nut To Install the Upper Handle and Crank AssemblyProtective To Assemble Snow Chute To CHECK/ADJUST Clutch Control CableHex Nylon Lever ControlCable..jFuel Know Your Snow ThrowerTo Control Snow Discharge HOW to USE Your Snow Thrower To Stop Your Snow ThrowerTo Move Forward ElectricStarterCheckthe OIL Before Starting the EngineTo Start Engine Electric Starter Fill GASPrimer Button Do not prime if temperature is aboveThree-hole, grounded 120 volt A.C ReceptacleAbove Warm StartFrozen Recoil Starter Snow Throwing TipsProduct Specifications Horse Power 5HP Displacement Customer Responsibilities Service Schedule Records DatesSnow Thrower Engine Lubrication Snow Thrower After First USESpark Plug To Adjust the Clutch Control CableOIL Recommendation To Replace Belt To Adjustthe Belt GuideTo Adjust Auger Drive Belt To Adjust or Replacethe To Adjust CarburetorSparkplug To Replace Auger Shear BoltSnow Thrower Storage Engine StorageTrouble Cause Correction Units fails toPropel itself