| Ignition Key |
Auger Drive | insert to run |
Clutch | pull out to stop |
Z_ CAUTION: Read owner'smanual before operating machine. Never direct discharge toward bystanders. Release the auger control bar and stop the engine before unclogging discharge chute or auger housing and before leaving the machine.
The operation of any snow thrower can re- sult in foreign objects being thrown into the eyes, which can result in severe eye dam- age. Always wear safety glasses or eye shields while operating the snow thrower.
We recommend standard safety glasses or a wide vision safety mask for over your
glasses, available at Craftsman Retail Stores or Service Centers.
TO CONTROL SNOW DISCHARGE
•Turn the crank assembly to set the direc- tion of the snow throwing.
•Loosen the wing knob on the chute de- flector and move the deflector to set the distance. Move the deflector (Up) for more distance, (Down) for less distance. Then tighten the wing knob (see figure below).
Knob
HOW TO USE YOUR SNOW
THROWER
TO STOP YOUR SNOW THROWER
•To stop throwing snow, release the auger drive lever (see bottom right figure on this
page).
•To stop the engine, push the throttle con- trol lever to • (Stop) and pull out the
ignition key (see figure below).
NOTE: Do Not turn key.
ElectricStarter
Primer Button
TO MOVE FORWARD
•Push down the auger drive lever (see figure below). The auger will assist in self propelling the unit.
•To reduce the forward drive motion, push down on the handle, lifting the auger housing.
Auger Drive Lever
|
| / |
|
| TO THROW SNOW |
|
| • Push down the auger drive lever (see |
Ignition |
| figure above). |
| • Release to stop throwing snow. | |
Key |
| |
| Starter | |
|
| |
| Throttle | Handle |
Control | Control |
|
9