Husqvarna 12530HV warranty Troubleshooting, Problem Cause Correction

Page 20
20

TROUBLESHOOTING

See appropriate section in manual unless directed to a service center/department.

PROBLEM

CAUSE

CORRECTION

 

 

 

 

 

Does not start

1.

Fuel shut-off valve (if so equipped)

1.

Turn fuel shut-off valve to OPEN position.

 

 

in OFF position.

 

 

 

2.

Safety ignition key is not inserted.

2.

Insert safety ignition key.

 

3.

Out of fuel.

3.

Fill fuel tank with fresh, clean gasoline.

 

4.

Throttle in STOP position (or ON/

4.

Move throttle to FAST position (or ON/OFF switch to ON position).

 

 

OFF switch is OFF).

 

 

 

5.

Choke in OFF position.

5.

Move to FULL position.

 

6.

Primer not depressed.

6.

Prime as instructed in the Operation section of this manual.

 

7.

Engine is flooded.

7.

Wait a few minutes before restarting, DO NOT prime.

 

8.

Spark plug wire is disconnected.

8.

Connect wire to spark plug.

 

9.

Bad spark plug.

9.

Replace spark plug.

 

10.

Stale fuel.

10.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

11.

Water in fuel.

11.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

Loss of power

1.

Spark plug wire loose.

1.

Reconnect spark plug wire.

 

2.

Throwing too much snow.

2.

Reduce speed and width of swath.

 

3.

Fuel tank cap is covered with ice or

3.

Remove ice and snow on and around fuel tank cap.

 

 

snow.

 

 

 

4.

Dirty or clogged muffler.

4.

Clean or replace muffler.

 

 

 

 

 

Engine idles or

1.

Choke is in FULL position.

1.

Move choke to OFF position.

runs roughly

2.

Blockage in fuel line.

2.

Clean fuel line.

 

 

3.

Stale fuel.

3.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

4.

Water in fuel.

4.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

5.

Carburetor is in need of adjustment

5.

Contact an authorized service center/department.

 

 

or overhaul.

 

 

Excessive

1.

Loose parts or damaged augers or

1.

Tighten all fasteners. Replace damaged parts. If vibration

vibration

 

impeller.

 

remains, contact an authorized service center/department.

Recoil starter is

1.

Frozen recoil starter.

1.

See “IF RECOIL STARTER HAS FROZEN” in the Operation

hard to pull

 

 

 

section of this manual.

Loss of traction

1.

Drive belt is worn.

1.

Check / replace drive belt.

drive / slowing of

2.

Drive belt is off of pulley.

2.

Check / reinstall drive belt.

drive speed

3.

Friction drive wheel is worn.

3.

Contact an authorized Sears service center/department.

 

 

 

 

 

 

Loss of snow

1.

Auger belt is off of pulley.

1.

Check / reinstall auger belt.

discharge or

2.

Auger belt is worn.

2.

Check / replace auger belt.

slowing of snow

3.

Clogged discharge chute.

3.

Clean snow chute.

discharge

 

4.

Augers / impeller jammed.

4.

Remove debris or foreign object from augers / impeller.

 

 

 

 

 

Lights not On

1.

Motor not running.

1.

Start engine.

 

2.

Loose wire connection.

2.

Check wire connections at engine and light.

 

3.

LED burnt out.

3.

Replace LED light module. (Individual LEDs are not replaceable)

 

 

 

 

 

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 115 61 Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Carriage BoltsAssembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerRemove Snow Thrower from Carton Unfold Upper HandleInstall Traction Drive Control ROD See Figs Install Auger Control ROD See FigsCheck Tire Pressure Install Discharge Chute / Chute Rotator Head See FigInstall Chute Deflector Remote Control See Figs Operation Know Your Snow ThrowerPrimer Ignition KEYMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting engineHOW to USE Your Snow Thrower StoppingTo Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Adjust Skid Plates See Fig Before Starting the EngineScraper BAR See Fig Check Engine OIL Level See FigSnow Throwing Tips To Start EngineBefore Stopping If Recoil Starter has FrozenMaintenance ➀ SAE 30 Motor Oil ➁ See Engine Maintenance sectionGeneral Recommendations Before Each USEEngine CleaningSnow Thrower Service and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See FigTo Replace Belts See Fig To Adjust Cable Tension See Fig To Adjust Traction Belt and Auger Belt TensionTo Remove Wheels See Fig CarburetorStorage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionService Notes Service Notes Service Notes Consumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below 07/01/2013 TH

12530HV specifications

The Husqvarna 12530HV is a versatile and efficient lawn mower that combines performance with innovative technology, designed to meet the needs of both residential and commercial users. With its lightweight yet sturdy design, the 12530HV stands out in the market for its user-friendly features and advanced functionalities, making lawn maintenance a breeze.

One of the key features of the Husqvarna 12530HV is its powerful engine. Equipped with a robust 30cc engine, this mower boasts a high power-to-weight ratio, ensuring it can tackle even the toughest grass and terrain with ease. The engine is designed for efficiency, providing reliable performance while minimizing fuel consumption.

The ergonomic design of the 12530HV enhances user comfort and control. The adjustable handle allows users to find the perfect height for mowing, reducing strain during extended use. Furthermore, the soft grip adds an extra layer of comfort for the operator, making long mowing sessions more enjoyable.

One of the standout technologies integrated into the Husqvarna 12530HV is its advanced cutting system. Featuring a variable speed option, this mower allows users to adjust the cutting speed according to the grass conditions, ensuring an optimal cut every time. The heavy-duty cutting deck is designed for durability, featuring high-quality blades that deliver precision cuts and a clean finish.

Another notable characteristic is the mower's high-capacity grass bag. Its ample size allows for extended mowing sessions without frequent stops for emptying, which is particularly beneficial for larger lawns. The bag is designed for easy attachment and removal, streamlining the mowing process.

Safety is a priority with the Husqvarna 12530HV. It comes equipped with a safety switch that ensures the engine stops when the user releases the handle, preventing accidental injuries. This feature, combined with the mower's stability and control, makes it a reliable choice for users of all experience levels.

Overall, the Husqvarna 12530HV is an excellent choice for those seeking a powerful, efficient, and user-friendly lawn mower. With its combination of advanced features, innovative technologies, and a focus on comfort and safety, it is well-equipped to handle a variety of mowing tasks, providing exceptional results with minimal effort. Whether for residential or commercial use, this mower is designed to deliver a superior mowing experience.
Top Page Image Contents