Husqvarna 125BVX Series manual Ground wire, Inlet cover, Cutters, Blower tube and nozzle, Fuel cap

Page 9
Ground wire

DESCRIPTION

Ground wire

SThe ground wire (G) reduces static build--up during operation in dry condi- tions.

G

Inlet cover

SAn inlet cover (H) is located on the side of the fan housing. Opening this cover allows access for cleaning and inspect- ing the impeller (125BX-SERIESand 125BVX-SERIESonly). If the vacuum tube is used, it must be fitted to the opening in the inlet cover. To open the inlet cover, use a tool to lift the edge of the cover opposite the hinge (indicated by arrow on inlet cover).

HInlet cover

J

WARNING: Never start the blower if the inlet cover is not closed, is damaged or cannot be closed (except if the vacuum tube is fitted).

Cutters

(125BX-SERIES and 125BVX-SERIES)

S Two cutters (J) are fastened to the impel- ler. The cutters are there to mulch leaves

and other debris that have been vacuumed before they enter the collection bag.

Blower tube and nozzle

NOTE: The tube clamp bolt and nut must

be installed prior to initial use (see the gen- eral description of the blower on page 6).

SThe blower tube (K) has a pegged slot mounting system to the unit. To install or remove the blower tube (or collection bag tube for the 125BVX-SERIES), the tube clamp bolt must be removed. Align slot in the blower air outlet with the raised rib on the tube and insert tube until the holes in the tube and housing align. Re--insert the tube clamp bolt and tighten.

545154658 Rev. 2 7/10/07

SThe nozzles (L) have a bayonet mount for connection to the blower tube. Air is channeled through the blower tube to the nozzles, where the air discharge velocity increases and the air stream discharge pattern is formed to provide best perfor- mance. The length of the blower tube can be adjusted by twisting the nozzle to the left to disengage the bayonet mount and sliding the nozzle to the appropriate position. Twist the nozzle to the right until a click is felt to resecure the nozzle.

K

L

Starter device and starter handle

SThe starter device (M) is located on the side of the engine shrouding and en- gages the crankshaft only when the starter handle (N) is pulled.

N

M

Fuel cap

SThe fuel cap (O) is located at the rear of the engine shrouding on the fuel tank and has a seal to prevent fuel from leak- ing out.

P

O

Air filter

SThe air filter (P) consists of a fiber filter medium in a resilient frame. The air filter should be cleaned at specific intervals (see Maintenance section). Otherwise, the blower will consume too much fuel, the performance will be reduced and an oily deposit may form on the spark plug electrodes.

English--- 9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents EN FR ES Contents CONTENTSNote the following before starting For customer assistance, callKEY TO SYMBOLS WARNING! The blowWARNING! Make sure Personal safety equipment SAFETY INSTRUCTIONSPersonal safety Fuel safetyOther safety measures The blower DESCRIPTIONAccessories 125BX-SERIES and 125BVX-SERIES 22. Collection bag tube 23. Collection bag24. Vacuum tube in two sections 25. Screw 26. Shoulder strap Fan housing Stop switchOther equipment Throttle triggerInlet cover Ground wireCutters Blower tube and nozzleChoke Adjusting the carburetor NOT FOR ALL MODELSFuel mixture FUEL HANDLINGFueling GasolineStarting and stopping STARTING AND STOPPINGCold engine Warm engineTo blow away debris on the ground USING THE BLOWERFitting the blower tube and nozzle on the blower BlowingStandard nozzle To vacuum debris from the ground 125BX-SERIES andHigh-velocity nozzle Fitting the collection bag with the various vacuum tubesVacuuming Maintenance Safety MAINTENANCEBasic setting Fine adjustment of the idle speed-TCooling system Cleaning the air filterAir filter DD EEFFDaily maintenance Maintenance scheduleWeekly maintenance Monthly maintenanceTechnical data TECHNICAL DATAWeight Approved accessoriesLifetime Warranty Ignition coils and mo- dules WARRANTY STATEMENTSECTION 1 LIMITED WARRANTY SECTION 2 HUSQVARNA’S OB- LIGATIONS UNDER THE WARRANTYMANUFACTURER’S WARRANTY COVERAGE YOUR WARRANTY RIGHTS AND OBLIGATIONSOWNER’S WARRANTY RESPONSI- BILITIES WARRANTY COMMENCEMENT DATEEMISSION CONTROL WARRANTY PARTS LIST MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION RE- LATED PARTSMAINTENANCE STATEMENT Intermediate 125 hours Extended 300 hoursEN FR ES Indice INDICEAntes de arrancar, observe lo siguiente ADVERTENCIA Bajo ninguSímbolo Descripción SIMBOLOS UTILIZADOS EN ESTE MANUALUbicación Símbolo Descripción UbicaciónEquipo de protección personal REGLAS DE SEGURIDADReglas de personal Seguridad con el combustible ¡ADVERTENCIA! El combusOtras reglas de seguridad Soplador de hojas DESCRIPCIONAccesorios 125BX-SERIES y 125BVX-SERIES 22. Tubo de la bolsa de colección 23. Bolsa de colección24. Tubo de aspiración 2 piezas 25. Tornillo 26. Arnés Interruptor de parada Equipo de seguridad¡ADVERTENCIA! Durante el Otros equiposAlambre para tierra ¡ADVERTENCIA! No ponga enTapa de entrada de aire CuchillasFiltro de aire EstranguladorReglage del carburador NO ESTÁ DISPONIBLE EN TODOS LOS MODELOS Carburante MANIPULACION DEL COMBUSTIBLEADVERTENCIA Para hacer la GasolinaNo fume ni ponga objetos calientes cerca del combustible RepostajeArranque y parada ¡ADVERTENCIA! No ponga en ARRANQUE Y PARADA¡ADVERTENCIA! Nunca enros Motor frioLimpieza de suelos soplando MANEJO¡ADVERTENCIA! El montaje del ¡ADVERTENCIA! Para trabajarLimpieza de suelos aspirando 125BX-SERIES y ¡ADVERTENCIA! El soplador deBoquilla estándar Boquilla de alta velocidadAspiración ¡ADVERTENCIA! Antes de ponerhojas no se debe utilizar montado en escaleras ni andamios 3. Guantes protectores homologadosSeguridad de mantenimiento MANTENIMIENTO¡ADVERTENCIA! El mantenimi CarburadorSistema de refrigeración ADVERTENCIA Recuerde queFiltro de aire Limpieza del filtro de aireEsquema de mantenimiento BujíaMantenimiento diario Mantenimiento semanalDATOS TECNICOS Accessoires homologuésDatos técnicos MotorSECCION 1 GARANTIA LIMITADA DECLARACION DE GARANTIASECCION 2 OBLIGACION DE HUSQVARNA BAJO GARANTIA SECCION 3 ARTICULOS NO CU- BIERTOS BAJO ESTA GARANTIASUS DERECHOS Y OBLIGACIONES DE GARANTIA CUBIERTA DE GARANTIA DEL FAB- RICANTEGARANTIA DE RESPONSABILIDAD DE DEL DUENO FECHA DEL COMIENZA DE LA GARANTIA DIAGNOSTICODURACION DE LA GARANTIA QUE CUBRE LA GARANTIA REPA- RACION O REEMPLAZO DE PIEZASPage 545154658 Rev. 2 7/10/07 BRW
Related manuals
Manual 4 pages 16.45 Kb Manual 4 pages 16.33 Kb

125BVX Series, 125B specifications

The Husqvarna 125B is a versatile and efficient hand-held leaf blower designed for both residential and professional use. With a focus on performance, ease of use, and environmental sustainability, this machine is perfect for maintaining gardens, yards, and outdoor spaces.

One of the standout features of the Husqvarna 125B is its powerful 28cc two-stroke engine, which delivers strong airspeed and airflow while ensuring fuel efficiency. This engine is capable of producing airspeeds of up to 170 mph, allowing users to clear debris, leaves, and grass clippings with ease. The lightweight design, weighing only 9.5 lbs, makes it easy to handle and operate for extended periods without causing fatigue.

The Husqvarna 125B also incorporates advanced technologies aimed at maximizing user comfort and performance. Its Smart Start mechanism allows for easy starting with minimal effort, which is especially useful for users who may struggle with traditional pull starts. This feature reduces resistance in the starter cord by up to 40%, enabling quick ignition of the engine.

Operator comfort has been prioritized in the design of the 125B, featuring an ergonomic handle that reduces vibration during operation. The blower's anti-vibration system dampens vibrations, allowing for prolonged use without discomfort. Additionally, the cruise control feature allows the user to set the desired speed, ensuring consistent performance over long periods while minimizing strain on the hand and wrist.

Another notable characteristic of the Husqvarna 125B is its environmentally friendly approach. The engine is designed with low emissions technology to comply with stringent environmental regulations, ensuring a smaller carbon footprint. This eco-friendly design does not compromise on power or efficiency, making the 125B a responsible choice for those who care about their impact on the environment.

In summary, the Husqvarna 125B is a robust and user-friendly leaf blower, ideal for maintaining outdoor spaces efficiently and effectively. With its powerful engine, lightweight design, and thoughtful features, it is well-suited for both homeowners and professionals alike. Whether tackling autumn leaves or maintaining year-round cleanliness, the Husqvarna 125B provides a reliable solution that combines performance with environmental responsibility.
Top Page Image Contents