Bolens C Style warranty Operator’S Manual, Two-Stage Snow Thrower - C, D Style

Page 1
OPERATOR’S MANUAL

Safety • Assembly • Operation • Maintenance • Troubleshooting • Parts Lists • Warranty

OPERATOR’S MANUAL

Two-Stage Snow Thrower — C, D Style

IMPORTANT

READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION

Warning: This unit is equipped with an internal combustion engine and should not be used on or near any uniiproved forest-covered, brush- covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.

 

MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019

PRINTED IN U.S.A

FORM NO. 769-01274D

 

08/05/2005

Image 1
Contents Two-Stage Snow Thrower - C, D Style OPERATOR’S MANUALMTD LLC, P.O. BOX 361131 CLEVELAND, OHIO Finding and Recording Model Number Table of ContentsCustomer Support WarrantyRestrict the use Safety Labelsin this manual and on the machine Your ResponsibilityPractices Safe OperationTrainingPreparation HEED ITS WARNING Your Responsibility Restrict the useSafe Operation Practices Maintenance & StorageOperation Do not modify engine3. Position the chute assembly over the base Setting Up Your Snow ThrowerTire Pressure Know Your Snow Thrower Operating Your Snow ThrowerExtinguish cigarettes, cigars, pipes and other sources of ignition ForwardAuger Control Stopping The Engine Gas & Oil Fill-UpIf your home’s Electric StarterTo Engage Drive Chute Clean-Out ToolTo Engage Augers Recoil StarterMaking Adjustments To adjust the skid shoes Engine Maintaining Your Snow ThrowerGear Shaft Wheelsreplacement auger belt Auger Belt Replacementproceed as follows place a piece of plastic under the gas cap3. a. Grasp the idler pulley and pivot it toward the right Reassemble the side plates with a new rubber ring Friction Wheel RemovalPreparing Engine Off-Season StoragePreparing Snow Thrower Problem Trouble ShootingCause RemedyStyles C & D To order replacement parts, contact Illustrated Parts Listor visit Styles C & D Screw, Self-tapping, 5/16-18 631-04133Washer, Flat, .350 sq. x Panel, Handle, no cutout C-StyleStyles C & D To order replacement parts, contact Illustrated Parts Listor visit Page Page MANUFACTURER’S LIMITED WARRANTY FOR