Bolens D Style, C Style warranty Safety Labels, Restrict the use, in this manual and on the machine

Page 3

Safety

��

��
��
	��
	��
	�
��	��
��	��
��	��
��	��
	��
	��
��	��
��	��
	��		��
	��		��
	��		��
��	��		��
��	��		��


��			��

��

��

��

��

��

��

��

��

��

A chute clean-out tool is fastened to the top of the

�� auger housing with a mounting clip. The tool is designed to clear a chute assembly of ice and snow.

This item is fastened with a cable tie at the factory. Cut the cable tie before operating the snow thrower.

WARNING: Never use your hands to clear a clogged chute assembly. Shut off engine and remain behind handles until all moving parts have stopped before using the clean-out tool to clear the chute assembly.

1

Safety

Labels

WARNING

This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before at- tempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol.

HEED ITS WARNING!

Your Responsibility

Restrict the use

of this power machine to persons who read, understand

and follow the warnings and instructions

in this manual

and on the machine.

3

Image 3

Contents OPERATOR’S MANUAL Two-Stage Snow Thrower - C, D StyleMTD LLC, P.O. BOX 361131 CLEVELAND, OHIO Warranty Table of ContentsFinding and Recording Model Number Customer SupportYour Responsibility Safety LabelsRestrict the use in this manual and on the machineHEED ITS WARNING Your Responsibility Restrict the use Safe OperationPractices TrainingPreparationDo not modify engine Maintenance & StorageSafe Operation Practices Operation3. Position the chute assembly over the base Setting Up Your Snow ThrowerTire Pressure Forward Operating Your Snow ThrowerKnow Your Snow Thrower Extinguish cigarettes, cigars, pipes and other sources of ignitionAuger Control Electric Starter Gas & Oil Fill-UpStopping The Engine If your home’sRecoil Starter Chute Clean-Out ToolTo Engage Drive To Engage AugersMaking Adjustments To adjust the skid shoes Wheels Maintaining Your Snow ThrowerEngine Gear Shaftplace a piece of plastic under the gas cap Auger Belt Replacementreplacement auger belt proceed as follows3. a. Grasp the idler pulley and pivot it toward the right Reassemble the side plates with a new rubber ring Friction Wheel RemovalOff-Season Storage Preparing EnginePreparing Snow Thrower Remedy Trouble ShootingProblem CauseStyles C & D Illustrated Parts List To order replacement parts, contactor visit Styles C & D Panel, Handle, no cutout C-Style 631-04133Screw, Self-tapping, 5/16-18 Washer, Flat, .350 sq. xStyles C & D Illustrated Parts List To order replacement parts, contactor visit Page Page MANUFACTURER’S LIMITED WARRANTY FOR