Bolens D Style, C Style warranty Setting Up Your Snow Thrower, Tire Pressure

Page 7

Tire Pressure

5.Remove the flat washer and hairpin clip from the end of the chute directional control.

Insert the end of the chute directional control into the lower bracket and secure with the flat washer and hair- pin clip just removed. If necessary, the lower bracket can be adjusted. Refer to Chute Bracket Adjustment. on Page 13.

6.Insert the shift lever through the speed select panel and secure to the shift spring lever with the two hex head bolts and flange lock nuts that come attached to the shift lever.

IMPORTANT: Prior to operating your snow thrower, refer to Auger Control Test on page 11. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.

Tire Pressure

Before operating, check tire pressure and reduce pres- sure in both tires to between 15 psi and 20 psi.

NOTE: If the tire pressure is not equal in both tires, the unit may not travel in a straight path and the shave plate may wear unevenly.

5

�

3

Setting Up

Your Snow

Thrower

IMPORTANT Prior to operating your snow thrower, refer to Auger Control Test on page 11. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.

7

Image 7

Contents Two-Stage Snow Thrower - C, D Style OPERATOR’S MANUALMTD LLC, P.O. BOX 361131 CLEVELAND, OHIO Warranty Table of ContentsFinding and Recording Model Number Customer SupportYour Responsibility Safety LabelsRestrict the use in this manual and on the machineHEED ITS WARNING Your Responsibility Restrict the use Safe OperationPractices TrainingPreparationDo not modify engine Maintenance & StorageSafe Operation Practices Operation3. Position the chute assembly over the base Setting Up Your Snow ThrowerTire Pressure Forward Operating Your Snow ThrowerKnow Your Snow Thrower Extinguish cigarettes, cigars, pipes and other sources of ignitionAuger Control Electric Starter Gas & Oil Fill-UpStopping The Engine If your home’sRecoil Starter Chute Clean-Out ToolTo Engage Drive To Engage AugersMaking Adjustments To adjust the skid shoes Wheels Maintaining Your Snow ThrowerEngine Gear Shaftplace a piece of plastic under the gas cap Auger Belt Replacementreplacement auger belt proceed as follows3. a. Grasp the idler pulley and pivot it toward the right Reassemble the side plates with a new rubber ring Friction Wheel RemovalPreparing Engine Off-Season StoragePreparing Snow Thrower Remedy Trouble ShootingProblem CauseStyles C & D To order replacement parts, contact Illustrated Parts Listor visit Styles C & D Panel, Handle, no cutout C-Style 631-04133Screw, Self-tapping, 5/16-18 Washer, Flat, .350 sq. xStyles C & D To order replacement parts, contact Illustrated Parts Listor visit Page Page MANUFACTURER’S LIMITED WARRANTY FOR