Operation
NO | FFO |
|
Figure 8
1.Place the spreader on a driveway or sidewalk – not on the lawn. Make sure the spreader is off by pushing the control knob in. See Figure 8.
2.Determine the recommended application and spreader settings of the material to be applied (check the product container).
Figure 9
3.Rotate the rate cam to the proper setting. See Figure 9.
4.Fill the hopper with the product to
be spread.
IMPORTANT!
Always begin moving the spreader before you open the control by pushing the thumb release to the ON position, and push the control knob in to CLOSE before stopping.
CAUTION!
During operation, always push the spreader; never pull!
5.Hold the handle so the top of the hopper is level. Start the spreader moving, then push the thumb release to the ON position and begin applying the material. Avoid tipping the spreader; doing so can cause an uneven application.
IMPORTANT!
The settings and swath widths are recommended starting points. Always check the delivery rate and pattern on a small area before treating a large area. Actual delivery rate can vary due to weather conditions, walking speeds, and the condition of the product being applied.
See pages
Fasteners
The Fastener Bag contains these fasteners. Most are all common parts; replacements are available at local hardware outlets.
1/4" Flat Washer | Wire Attachment | ||
(6 Req.) | (4 Req.) | (8 Req.) | Clip (1 Req.) |
5/32 x 2" Cotter Pin |
| 1/8 x 1" Cotter Pin | |
(2 Req.) | (1 Req.) |
| (1 Req.) |
4 | 9 |