Front Roller Option
Assembly Instructions
Use with 15 Series 48" & 72" Overseeder | Manual No. | ||
|
|
|
|
Before You Start
When you see this symbol, the subsequent
!instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it!
IMPORTANT: Before you begin, read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation instructions for future reference and parts ordering information.
These optional assembly instructions contain only information on assembling the attachment to the main unit. Please read these installation instructions and the vehicle Operator’s Manual thoroughly before beginning. Especially read information relating to safety concerns. Also included in the Operator’s Manual is important information on operation, adjustment, troubleshooting, and maintenance for this attachment (some manual sections do not apply to all accessories).
A separate Parts Manual for replacement parts can be purchased from your dealer or available free of charge at www.landpride.com. Have model and serial numbers handy when placing an order.
Manual Part Numbers:
•Operator’s Manual . . . . . . . . . . . . . . . . .
•Parts Manual . . . . . . . . . . . . . . . . . . . . .
General Information
These option assembly instructions apply to the Front Roller Packages listed below:
Starting on page 3 is a detailed listing of parts included in these kits. Use this list as a checklist to inventory parts received.
Assembly Instructions
Installation Instructions
Refer to Figure 1 for front roller mounting hole locations.
Refer to Figure 2:Attach the floating top link (#1) to the overseeder hitch using the spacer tube (#2), a 3/4" x 4" long bolt (#3), 3/4" lock washer (#4) and a 3/4" hex nut (#5).
If the front roller arm (#6) and the front roller (#7) are not assembled, bolt them together with a 1/2" x 1 1/2" long bolt (#8), 1/2" lock washer (#9) and a 1/2" hex nut (#10).
Attach that assembly to your overseeder using 5/8" x 2" long bolts (#11), 5/8" lock washers (#12) and 5/8" hex nut (#13).
14801 |
Hole Locations Typical on Both Ends of Seeder
Figure 1
Use the 1/2" x 2 1/2" x 3 1/2" long
NOTE: Some of the above parts may already be assembled.
14802 |
Front Roller Assembly
Figure 2
© Copyright 2005 Pr inted 11/08/05 | Manual No. | 1 |