Special Set-Up Procedure, Drive Belt Height, Disassembly

Special Set-Up Procedure

WARNING – Turn off electrical power and air supply and disconnect power

cord from electrical supply before beginning special set-up procedure. If power cord is not disconnected, severe injury to personnel could result.

Changing Drive Belt Height

The drive belt assemblies can be raised 50 mm

[2 inches] to provide better conveying of tall boxes.

This change increase the minimum box height that can be taped to 190 mm [7-1/4 inches].

DISASSEMBLY – Figure 6-1

1.Using the height adjustment crank, raise the upper taping head to its fully raised position.

2.Remove and retain the M6 x 16 flat head cap screw (A), special washer (B) and spacer (C) from the front and rear arm assembly pivots.

3.Lift drive belt assembly (D) up off the arm assembly pivots.

Note – Keep motor in vertical position to prevent gear oil from leaking out of motor.

REASSEMBLY – Figure 6-2

4.Reassemble the spacer (C) onto the front and rear arm assembly pivots first.

5.Install the belt drive assembly (D) onto the pivots and secure with special washers (B) and M6 x 16 flat head cap screws (A).

Note – Both drive belt assemblies must be installed at the same operating height.