3M 800af manual Damage Upper Taping Head Leveling

Adjustments (Continued)

WARNING – Turn air and electrical supplies off and disconnect before beginning adjustments. Failure to comply with this warning could result in severe personal injury or equipment

damage.

Upper Taping Head Leveling

If the upper taping head is not horizontal, it can be leveled by adjusting the self-locking nut.

1.Loosen the five bolts on each side of crossbar shown in Figure 5-2A.

2.Remove access cover as shown in Figure 5-2B and (using M13 hex key wrench) tighten or loosen M8 self-locking nut until upper head is level.

3.Take measurement from exit end of upper head assembly and front of flap folding ski to machine bed, as shown in Figure 5-2. Upper assembly must be level ±1.5 mm [±1/16 inch].

4.Retighten five bolts on each side of crossbar to secure adjustment.

Figure 5-2 – Upper Taping Head Leveling

30