NOTE:
Do not look through the telescope's eyepiece or viewfinder while it is rapidly moving. Children should always have adult supervision while observing.
2.Verify that AutoStar is properly connected to your telescope. See “HOW TO ASSEMBLE YOUR TELESCOPE,” page 13.
3.Flip the telescope power switch to the ON position.
The AutoStar screen is activated and a copyright message displays briefly, followed by a short beep. Then AutoStar takes a few moments to start up the system.
4.A message displays that warns not to look at the Sun. At the end of this message, press the key prompted by AutoStar to signify that the message has been read and understood.
5.The Arrow keys are now activated. Press the Arrow keys (5, Fig. 2) to slew (move) the telescope up, down, right, or left.
6.Press a Number key (8, Fig. 2) to change the telescope’s slew speed. See "SLEW SPEEDS," below, for more information.
7.Use SmartFinder (17, Fig. 1) and/or the viewfinder (1, Fig. 20) to locate an object and prac- tice using the AutoStar’s Arrow keys to center the object in the telescope’s field of view.
8.Use the telescope’s focus knob (8, Fig. 1) to bring the object into focus.
Slew Speeds
AutoStar has nine slew speeds that are directly proportional to the sidereal rate and have been calculated to accomplish specific functions. Pressing a Number key changes the slew speed, which is shown for about two seconds on AutoStar’s display.
The nine available speeds are:
Number Key 1 | = | 1x | = | 1 x sidereal (0.25 |
Number Key 2 | = | 2x | = | 2 x sidereal (0.5 |
Number Key 3 | = | 8x | = | 8 x sidereal (2 |
Number Key 4 | = | 16x | = | 16 x sidereal (4 |
Number Key 5 | = | 64x | = | 64 x sidereal (16 |
Number Key 6 | = 128x | = | 32 | |
Number Key 7 | = | 1.5° | = | 90 |
Number Key 8 | = | 3° | = | 180 |
Number Key 9 | = | Max | = | 390 |
Speeds 1, 2, or 3: Best used for fine centering of an object in the field of view of a higher power eyepiece, such as a 12mm or a 9mm eyepiece.
Speeds 4, 5, or 6: Enables centering an object in the field of a
Speeds 7 or 8: Best used for rough centering of an object in the eyepiece.
Speed 9: Moves the telescope quickly from one point in the sky to another
Observe the Moon
Point your telescope at the Moon (note that the Moon is not visible every night) and practice using the Arrow keys and the slew speeds to view different features. The Moon contains many interesting features, including craters, mountain ranges, and fault lines. The best time to view the Moon is during its crescent or half phase. Sunlight strikes the Moon at an angle during these periods and adds a depth to the view. No shadows are seen during a full Moon, causing the overly bright surface to appear flat and rather uninteresting. Consider the use of a neutral density Moon filter when observing the Moon. Not only does it cut down the Moon's bright glare, but it also enhances contrast, providing a more dramatic image.
17