iOptron N114 instruction manual Attaching Optics

Step 4. Attaching Telescope

Dovetail Attach telescope to mount using the dovetail lock knob (#2). lock (#2)

Point toward open end		Step 5. Attaching Optics
of telescope		Attaching the red dot finder scope (#6) to the telescope tube (#1):
	Bolts	First remove the two washers on the tube. Then place the finder scope
		onto the two bolts and re-attach the washers securely. The finder scope
		should face towards the open end of the tube (see arrow in diagram).
		Turn on the beam using the switch on the side. (note: you may need to
		remove the plastic insulation placed next to the battery underneath)
		Insert the eyepiece: Remove the supplied 25mm eyepiece (#7) from
	Switch	its container and slide it into the open end of eyepiece holder. Tighten
		the thumbscrews to a firm feel only.
	Eyepiece (#7) Remove the round dust cover lid from the end of telescope.
		Use the focus knob to bring objects into focus. You may need to turn
		the focus knob quite a few turns to focus your telescope for the first
		time. Always start observing using a lower power eyepiece (such as the
		25mm eyepiece) to get a wider field of view. Later on you can change
		to higher powers. (Eyepieces of higher powers have narrower field of
		views; it’s more difficult to locate objects using high-power eyepieces.)
	Focus knob
		Step 6. Connecting Hand Controller
		Plug hand controller into any one of the HBX (handbox) ports on the
		mount.
		Turn on power. Now you are ready to observe. Use the 4 Arrow keys
		(▲▼◄►) to rotate the scope Up, Down, Left, and Right. Use the
		SPEED key to change the slew speed from the slowest (2X) to the
		fastest (MAX).

7