Cerwin-Vega Explore the Features and Safety Tips for Cerwin Vega's CVP 2153 Speakers

Cerwin-Vega! CVP-2153 & CVP-1152 Loudspeaker Systems

3. BEFORE YOU BEGIN: SAFETY AND CARE FOR YOUR CVP LOUDSPEAKERS Positioning

High and upper mid frequencies are a crucial part of the audio spectrum, and have much to do with how we perceive clarity and intelligibility. Whereas these frequencies are the most easily located, they are also the first to be acoustically blocked. Taking the coverage angles of the models used into consideration, be sure to set up your speakers so that the MF and HF drivers are free from obstructions and the higher frequencies can reach the entire audience (e.g. slightly above the heads of the audience). This will ensure optimal dispersion of higher-frequency content and thus improved speech intelligibility and clarity.

Avoiding Feedback

Always place the "front-of-house” speakers (the enclosures facing the audience) in front of the microphones, (e.g. towards the front edge of the stage). Use professional floor wedges (e.g. CVP-1152) or other dependable monitoring systems to ensure that the performers on stage can hear themselves. Whenever possible, position monitor speakers so that they point only to the back side of microphones.

Avoiding Feedback When Using Turntables (e.g. DJ Applications)

Turntables often produce low-end feedback: low frequencies are fed back to the pickup arm and cartridge and reproduced again by the speakers. Common causes of low-end feedback are speakers positioned too close to the turntable or on wooden floors or stage elements prone to vibration. To avoid this, position the speakers as far from the turntable as possible. Placing them on a solid, non-resonating support will also help. If you are using the CVP-1152 model speakers, try mounting them on stands. This will minimize direct contact between floor and speakers and reduce vibration.

Protecting Your Speakers

Next to following common-sense rules like exercising caution while setting levels to avoid overdriving your power amps, and understanding and respecting the physical limits of your system, there are a couple reliable methods of protecting your speakers – and your entire system – using additional equipment. Using a high pass filter to avoid excessive low frequencies, low-frequency rumble or extreme low frequencies can lead to an excessive displacement of the speaker diaphragm and in turn to permanent damage. Using an equalizer or a low-cut/high pass filter to eliminate the low frequencies below the response curve of the speaker can effectively prevent this. Most consoles and outboard equalizers, as well as many other outboard signal processors and of course speaker management systems provide a high pass filter. The use of a high pass filter in the signal path is especially recommended when using turntables and/or CD players as signal sources. CD players often produce extremely low frequencies, which can lead to excessive diaphragm displacement. Using a limiter to limit the output level, Insert the limiter between the mixing console output and your power amp. Many types of outboard signal processors and most speaker management systems include limiters for this application. Used properly, they can eliminate overdriving of your audio signals and effectively suppress dangerous signal peaks, which can not only degrade the sound quality, but also cause permanent damage to your speakers and other system components.

Power Amplifier Selection

Choosing the right power amplifier has a major effect on the performance of your speakers. The amplifier should always provide at least as much power as the speaker system is capable of handling. In order to ensure precise reproduction of brief, high-power transients, the amp should provide about twice as much power as the speakers can handle. The minimum recommended input power ratings for CVP-1152 and CVP-2153 systems are displayed in the Specifications Table.

4