Intel TS-ASP3 Suspend Mode, HDD Power Down, Soft-Off by PWR-BTTN, Wake-Up by PCI & WOL, Date/Time

Page 45

BIOS SETUP

41

Suspend Mode

After the selected period of system inactivity (1 minute to 1 hour), all devices except the CPU will be shut down.

HDD Power Down

After the selected period of system inactivity (1 to 15 minutes), the hard disk drive powers down while all other devices remain active. This feature doesn’t effect SCSI hard drives.

Soft-Off by PWR-BTTN

When set to “Instant-off”, the ATX switch can be used as a normal system Power Off button. When set to “Delay 4 seconds”, you need to press the Power Off button down for more than 4 seconds if you want to Power Off the system.

Wake-Up by PCI & WOL

Select “Enabled” if you want to Power On your system when a PCI or LAN event occurs.

Power On by Ring

Select “Enabled” to Power On your system when the external modem receives a call.

NOTE: This function requires an external modem which supports the Ring Wake-

Up function.

USB KB Wake-Up From S3

When your system is in S3 (Suspend to RAM) mode, you can wake-up the system by pressing the wake-up key on the USB Keyboard.

CPU Thermal-Throttling

Select the CPU Thermal-Throttling rate. If BIOS detects that the CPU temperature is too high, it will slow down the CPU’s speed according to this field. The choices are: “87.5%”, “75.0%”, “62.5%”, “50.0%”, “37.5%”, “25.0%” and “12.5%”.

Resume by Alarm

Select “Enabled” if you want to power up your system at a certain time on the same day every month, or at a certain time every day.

Date/Time

Set the Date and Time to Power On the system. Activated only when the “Resume by

Alarm” field is enabled.

Reload Global Timer Events

When “Enabled”, an event occurring on any device listed below restarts the global timer from Standby Mode, and Powers On the system.

Image 45
Contents TS-ASP3 USER’S Manual TS-ASP3 Motherboard Table of Contents Software Setup Battery Replacement Essential Handling PrecautionsINTRODUCTION1 Static ElectricityPackage Contents Specifications and Features2INTRODUCTION Switching Voltage Regulator Award BiosINTRODUCTION3 Bus SlotOther Features PCB Dimensions4INTRODUCTION Transcend’s TS-ASP3 Motherboard Hardware Installation5 E P Layout of Transcend TS-ASP3 MotherboardJumper Setup 1 66/100/133 MHz System Configuration Hardware InstallationUsing Jumper JP1 to clear Cmos 8HARDWARE InstallationAudio Selection Jumper Onboard Audio Setting JP2 ON-BOARD AudioKeyboard Wake Up Keyboard Wake-Up 3-pin KB-AWKVCC3 Adjust 5 VCC3 AdjustIDE Connectors Floppy Disk Drive Connector Floppy Disk Drive Connector 34-pin FDCFan Power Connectors Unbuffered Position Memory ConfigurationPanel Connector Panel ConnectorsSuspend Mode LED Lead 2-pin Sled Wake-on-LAN Connector Wake-on-LAN Connector 3-pin WOLPower Connector Power Connector 20-pin PWR-CONNIrDA Connector IrDA-Compliant Infrared Module Connector 10-pin IrDAInternal Serial Port Connector Comb Internal Serial Port Connector CombInternal Audio Connector 22HARDWARE InstallationUSB 3/4 Connector USB 3/4 ConnectorBack Panel I/O Ports External Back Panel I/O PortsBios Setup Bios SetupMain Menu Advanced Bios Features Standard Cmos FeaturesAdvanced Chipset Features Power Management SetupStandard Cmos Features Bios Setup Drive A/Drive B Floppy Mode 3 SupportVideo Halt OnVirus Warning Advanced Bios FeaturesQuick Power On Self Test Processor Number FeatureFirst/Second/Third/Other Boot Device Boot Up Floppy SeekTypematic Rate Setting Boot Up NumLock StatusTypematic Delay Msec Delay For HDD SecsAdvanced Chipset Features CPU Latency Timer Video Bios CacheableDelayed Transaction Memory Hole at 15M-16MIntegrated Peripherals On-Chip Primary/Secondary PCI IDEIDE Primary/Secondary Master/Slave PIO Power On Function IDE HDD Block ModeIDE Primary/Secondary Master/Slave Udma USB ControllerHot Key Power On KB Power On PasswordUart Mode Select IR Transmission DelayParallel Port Mode Use IR PinsEPP Mode Select ECP Mode Use DMAPower Management Power Management SetupAcpi Function Acpi Suspend TypeVideo Off In Suspend Video Off MethodSuspend Type Modem Use IRQHDD Power Down Suspend ModePower On by Ring Resume by AlarmPnP/PCI Configuration Setup Reset Configuration DataResources Controlled by IRQ Resources PCI/VGA Palette SnoopPCI n Assignment PC Health Status Frequency/Voltage Control CPU Clock Ratio Load Optimized Defaults Load Fail-Safe DefaultsTo set a password Supervisor PasswordSave & Exit Setup User PasswordExit Without Saving INF Update for 815EP Chipset Software SetupIntel Security Controller Driver Audio Driver for Windows 95/98/2000 Audio Driver SetupSoftware Setup Audio Driver for Windows NT How to Check Your Bios File Name and Version How to Download the Correct Bios File from the WebP 3 Ver 1.01 11/22/00 How to Upgrade Your Motherboard Bios Bios Upgrade