User Guide XB1 COM Express Module
XB1 COM Express Module GPIO Usage ICH6
GPIO | Type | Tol. | Function | Description |
|
|
GPI 30 | I | 3.3V | BOARD_CFG2 | Board configuration options line 2 | ||
GPI 31 | I | 3.3V | BOARD_CFG3 | Board configuration options line 3 | ||
GPIO 32 | O | 3.3V |
| not used - open (configured as output by BIOS) | ||
GPIO 33 | O | 3.3V | NC1_OFF# | Enable Ethernet Controller NC1 | ||
GPIO 34 | I/O | 3.3V | ICH_GPIO34 | for future use as PLD control signal (either input or output) | ||
GPI 40 | I | 5V | PG_VR18 | Power Good signal from 1.8V voltage regulator | ||
GPI 41 | I | 3.3V | LPC_DRQCOM# | LPC Port DMA request from COM Express carrier board | ||
GPO 48 | O | 3.3V |
| not used - open |
|
|
GPO 49 | OD | 1.05V | CPU_PWRGD | CPU Power Good signal |
| |
|
|
| italic blue | |||
GPIO Usage FWH |
|
|
|
|
| |
|
|
| XB1 COM Express Module GPIO Usage FWH | |||
GPIO | Type | Tol. | Function | Description |
|
|
GPI 0 | I | 3.3V | FWH_ID | FWH Identity: Fixed to GND (indicates FWH #1) | ||
GPI 1 | I | 3.3V | IDE_CLBID# | IDE | ||
GPI 2 | I | 3.3V | WDOGRST | Last Hardware Reset caused by watchdog | ||
GPI 3 | I | 3.3V | LSB PCB REV | GPI 4 | GPI 3 | Rev. |
|
|
|
| 0 | 0 | 0 |
GPI 4 | I | 3.3V | MSB PCB REV | 0 | 1 | 1 |
1 | 0 | 2 | ||||
|
|
|
| 1 | 1 | 3+ |
©EKF | ekf.com |