Intel 82600 manual Installing and Replacing Components Before You Begin

Page 20

User Guide XB1 COM Express Module

Installing and Replacing Components

Before You Begin

Warnings

The procedures in this chapter assume familiarity with the general terminology associated with industrial electronics and with safety practices and regulatory compliance required for using and

modifying electronic equipment. Disconnect

the system from its power source and from

any telecommunication links, networks or

modems before performing any of the

procedures described in this chapter. Failure

to disconnect power, or telecommunication

links before you open the system or perform

any procedures can result in personal injury

or equipment damage. Some parts of the

system can continue to operate even though

the power switch is in its off state.

 

Caution

Electrostatic discharge (ESD) can damage components. Perform the procedures described in this

chapter only at an ESD workstation. If such a

station is not available, you can provide

some ESD protection by wearing an

antistatic wrist strap and attaching it to a

metal part of the system chassis or board

front panel. Store the board only in its

original ESD protected packaging. Retain the

original packaging (antistatic bag and

antistatic box) in case of returning the board to EKF for rapair.

©EKF

-20-

ekf.com

Image 20
Contents COM Contents User Guide XB1 COM Express ModuleUser Guide XB1 COM Express Module Contents/ Changes Legal Disclaimer Liability Exclusion Related Documents NomenclatureTrade Marks XB1 COM Express Module Features Feature Summary Feature Summary XB1Mtbf Short Description XB1 COM Express Module EKF Block Diagram XB1 COM Express Module 760Assembly Drawing XB1 COM Express Module CPUStrapping Headers Connectors & SocketsIndicators Microprocessor CPU IDThermal Considerations Main Memory LAN SubsystemSerial ATA Interface Sata Enhanced IDE Interface Pata1280x1024 1600x1200 2048x1536 Graphics Subsystem640x480 800x600 Firmware Hub Flash Bios Real-Time ClockUniversal Serial Bus USB LPC Super-I/O InterfaceGP General Purpose LED Watchdog/ResetPG Power Good LED Installing and Replacing Components Before You Begin Installing the Board Removing the Board EMC Recommendations Installing or Replacing the Memory Modules Replacement of the BatteryTechnical Reference Local PCI Devices NumberLocal SMB Devices Hardware Monitor LM87Gpio Usage Gpio Usage ICH6 XB1 COM Express Module Gpio Usage ICH6Gpio Usage FWH DescriptionGpio Usage SIO XB1 COM Express Module Gpio Usage SIOConfiguration Jumpers Reset Jumper Bios Cmos RAM Values J-GP Reset Jumper ICH6 RTC Core J-RTCConnectors PLD Programming Header IspconCOM SDVOBINT+ PEGRX1+ SDVOBGRN+ PEGTX1+ SDVOCRED+ PEGTX4+ EKF 275.50.00.440.00 ekf.com Processor Debug Header Pitp PitpSIO Board Dimensions COM ExpressTop View, Bottom View Theme Document Title Origin