Operating the PC Screen

You can use the remote control as a simplified mouse or keyboard.

CAUTION: Mistaken use of the mouse/keyboard control could damage your equipment.

•Only connect to a PC.

•Before connecting, read the manuals of the device you will connect.

•Do not unplug the connector cables while the computer is operating.

PS/2, ADB, Serial Mouse Control

1Turn off the projector and PC power, and connect the projector’s CONTROL terminal to the computer via the mouse cable.

2If a USB cable is connected, disconnect it. If a USB cable is connected, the USB control function is given priority, and mouse control from the CONTROL terminal will not function.

3Turn on the projector power, then the computer.

The functions in the table below can be controlled. If you have difficulty with control, restart the computer (either from the software or by pressing the restart button).

Available Functions		Remote Control Operation
Move Pointer	Use	,	,	,	button

Left click with mouse	Press ENTER button

Right click with mouse	Press RESET button

USB Mouse/Keyboard Control

1Connect the projector’s USB terminal to the computer using a USB cable. The functions in the table below can be controlled.

Available Functions		Remote Control Operation
Move Pointer	Use	,	,	,	button

Left click with mouse	Press ENTER button

Right click with mouse	Press RESET button

Press keyboard’s HOME key	Press HOME button

Press keyboard’s END key	Press END button

Press keyboard’s PAGE UP key	Press PAGE UP button

Press keyboard’s PAGE DOWN key	Press PAGE DOWN button

Press keyboard’s ESC key	Press ESC button

NOTES:

•It may not be possible to control notebook PCs, and other computers with built-in pointing devices (e.g. track balls), using this remote control. In this case, before connecting go into BIOS (system setup) and select external mouse, and disable the pointing devices. In addition, the mouse may not function if the computer does not have the needed utility program. See your computer’s hardware manual for details.

•The USB control can be used with Windows 95 OSR 2.1 or higher. It may not be possible to use the remote control, depending on the computer’s configurations and mouse drivers.

•The USB control can only be used for the functions listed above. You cannot do things like press two buttons at once (for instance, pressing two buttons at the same time to move the mouse pointer diagonally).

•This function is not available while the lamp is warming up (the POWER indicator flashes green), while adjusting the volume and display, correcting for trapezoidal distortion, zooming in on the screen, using the BLANK function, or displaying the menu screen.

ViewSonic PJ650