ViewSonic PJ650 manual Option Menu, Adjust Volume High, Adjust Auto OFF Time, Select Whisper Mode

Option Menu

With the OPTION menu, the five items shown in the Table below can be performed.

Please perform each operation in accordance with the instructions in the Table.

Item			Description
VOLUME	Adjust Volume: High		Low
AUTO OFF	Adjust AUTO OFF Time:
	Long (MAX. 99 min.)		Short (Min. 1 min.)	(DISABLE: 0 min.) The
	system automatically enters the standby mode if no signal is received within the set time. This
	function is inactive when DISABLE (0 min.) is selected.
WHISPER	Select WHISPER Mode:
	NORMAL		WHISPER
	When WHISPER is selected the WHISPER mode is activated. In the WHISPER mode, acoustic
	noise and screen brightness are reduced.
LAMP TIME	Refer to LAMP TIME: When set, this function displays the total time the projector lamp has been
	used since new.
	Reset LAMP TIME [Use this function only when the lamp has been replaced!]:
	Depress the RESET button for at least 3 seconds while lamp time is being displayed. The reset
	menu will then appear. After you replace the lamp with a new lamp, select RESET
	on the menu with the		button.
	• Do not reset the lamp time unless you have replaced the lamp. And, always reset the lamp time
		when replacing the lamp. The message functions will not operate properly if the lamp time is
		not reset correctly.
	• After the lamp running reaches 2000 hours, a warning message is displayed: “To maximize
		performance, lamp replacement is recommended.”, but won’t shut the unit off. The message
		display for 30 seconds when the PJ is turned on. If we push any button while displaying the
		message, the message disappears.
	• Before replacing the lamp, carefully read the descriptions headed "THE LAMP".
FILTER TIME	Refer to FILTER TIME: This function displays the total time the air-filter has
	been used since new.
	Reset FILTER TIME [Use this function only when the filter is cleaned or replaced!]:
	Depress the RESET button for at least 3 seconds while lamp time is being displayed. The reset
	menu will then appear. After you replace the filter, select RESET on the menu with
	the	button.
	DEFAULT		CANCEL
	• Do not reset the filter time unless you have cleaned or replaced the filter. And, always reset the
		filter time when cleaning or replacing the filter. The message functions will not operate properly
		if the filter time is not reset correctly.
	• Before cleaning or replacing the filter, carefully read the descriptions headed "THE AIR
		FILTER".

ViewSonic PJ650 30