|
|
GigPMC Switch | Board and Driver Users Manual |
TYPE=Ethernet
USERCTL=no
NETMASK=255.255.255.0
NETWORK=192.168.0.0
BROADCAST=192.168.0.255
Note: You should also add a line to /etc/modules.conf for each interface as shown in the following example:
SAMPLE MODULES.CONF FILE
alias eth1 dpm alias eth2 dpm alias eth3 dpm alias eth4 dpm
options dpm ChipSelector=1 IntrHoldOff=0
Note: In order to load the Intel driver, the "ChipSelector=1" option (the default) can be set in the 'options' field of modules.conf. Please see man page for modules.conf for additional information on module configuration.
MANUAL DRIVER INSTALLATION
insmod ./dpm.o # to insert driver module
ifconfig eth1 192.168.0.3 # if not already configured by system
Once driver is inserted you may need to run "ifconfig" command or it may be run automatically by the system.
MANUAL DRIVER REMOVAL
ifdown eth[n] | # | repeat for all 'dpm' network interfaces |
rmmod dpm | # | to remove driver module |
LOADING THE DRIVER FOR INTEL BASED MODELS (5261, 5262, 5164, etc.)
Note: In order to load the Intel driver, the "ChipSelector=1" option is not required during the 'insmod' as it is the default option:
insmod ./dpm.o [ChipSelector=1]
DSS NETWORKS, INC. | Version: 2.6 | Page: 30 |