Intel C50277-001, SC5275-E Maintaining Your Server, Safety Before You Remove the Access Covers

3 Maintaining Your Server

3 Maintaining Your Server

This chapter describes how to replace components in your server after it has been set up.

Tools and Supplies Needed

Phillips (cross head) screwdriver (#2 bit)

Small flathead screwdriver

Antistatic wrist strap (recommended)

Needle-nosed pliers

Safety: Before You Remove the Access Cover(s)

Before removing the access cover for any reason, observe these safety guidelines:

1.Turn off all peripheral devices connected to the server.

2.Turn off the server by pressing the power button on the front of the chassis.

3.Unplug the AC power cord from the chassis or wall outlet.

4.Label and disconnect all peripheral cables and all telecommunication lines connected to I/O connectors or ports on the back of the chassis.

5.Provide some electrostatic discharge (ESD) protection by wearing an antistatic wrist strap attached to chassis ground—any unpainted metal surface—when handling components.

Warnings and Cautions

These warnings and cautions apply whenever you remove the access cover(s) to access components inside the server. Only a technically qualified person should integrate and configure the server.

WARNINGS

The power button on the front panel DOES NOT turn off the AC power. To remove power from server, you must unplug the AC power cord from the wall outlet or the chassis.

Hazardous electrical conditions may be present on power, telephone, and communication cables. Turn off the server and disconnect the power cords, telecommunications systems, networks, and modems attached to the server before opening it. Otherwise, personal injury or equipment damage can result.

Hazardous voltage, current, and energy levels are present inside the power supply. There are no user-serviceable parts inside it; servicing should be done by technically qualified personnel.

Intel® Entry Server Chassis SC5275-E User Guide 29