ViewSonic PJ513DB warranty FCC Statement, For Canada, CE Conformity for European Countries

Page 2

Compliance Information

FCC Statement

This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Warning: You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

For Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

CE Conformity for European Countries

The device complies with the requirements of the EEC directive 89/336/EEC as amended by 92/31/EEC and 93/68/EEC Art.5 with regard to “Electromagnetic compatibility”, and 73/23/EEC as amended by 93/68/EEC Art.13 with regard to “Safety.”

Following information is only for EU-member states:

The mark shown to the right is in compliance with the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE).

The mark indicates the requirement NOT to dispose the equipment as unsorted municipal waste, but use the return and collection systems according to local law.

ViewSonic

PJ513D/PJ513DB

Image 2
Contents ViewSonic CE Conformity for European Countries FCC StatementFor Canada Following information is only for EU-member statesImportant Safety Instructions Declaration of RoHS Compliance Copyright Information Table of Contents Introduction Projector featuresShipping contents Rear side Projector exterior viewFront/upper side Under sideControls and functions ProjectorMODE/ENTER Remote control BlankRemote control effective range Replacing the remote control batteryPositioning your projector Choosing a locationObtaining a preferred projected image size ViewSonic PJ513D/PJ513DB Feet Inches Connection Connecting a computer or monitorConnecting a computer Connecting a monitor Connecting Video source devices Best video qualityConnecting a Component Video source device To connect the projector to a Component Video source deviceConnecting an S-Video source device To connect the projector to an S-Video source deviceConnecting a composite Video source device Operation Start upSwitching input signal VideoAuto-adjusting the image Adjusting the projected imageAdjusting the projection angle Fine-tuning the image size and clarityCorrecting keystone For exampleSelecting the aspect ratio Selecting a preset mode Optimizing the imageFine-tuning the image quality in user modes Setting the User 1/User 2 modeAdjusting Color Hiding the image Locking control keysFreezing the image Operating in a high altitude environmentAdjusting the sound Personalizing the projector menu displayShutting down the projector Menu operation Menu systemSetup Basic AdvancedUsing the menus Following example describes the adjustment of KeystoneDisplay menu Picture menuSource menu System Setup Basic menu Lamp System Setup Advanced menuAudio Status Information menuCurrent System Maintenance Care of the projectorExtending lamp life Lamp informationGetting to know the lamp hour Message Status Replacing the lamp Restart the projector Temperature information IndicatorsLight Status & Description Power Temp Lamp Thermal events Troubleshooting Projector does not turn onSpecifications Projector specificationsDimensions Signal Format Horizontal Vertical Frequency Frequency kHz Timing chartHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Customer Support Limited Warranty Limitation of implied warranties Mexico Limited Warranty Número Gratis DE Asistencia Técnica Para Todo México
Related manuals
Manual 57 pages 235 b