ViewSonic ND4210w manual If any changes were made to this screen, do the following

Page 20

2.In the Browser field, enter a startup web screen (for example, http://www.viewsonic.com). Note: The MAC address is a read-only field that displays the built-in MAC address of the unit.

3.In the DHCP field of the Network Configuration screen, tap the down arrow for the pull- down menu and select Enabled to dynamically get network parameters. Make sure there are values in the IP address, Mask, Gateway, and DNS fields although DHCP assigns values to these fields automatically. If you select Disabled, type valid network parameters in these fields.

4.If any changes were made to this screen, do the following:

•To enable the changes, click Apply

•To save the changes, click the Administration menu > click Save Configuration > click Save.

12	ViewSonic ND4210w

Downloaded From TV-Manual.com Manuals

Image 20

Contents Page This page left blank for dual-sided printing Product disposal at end of product life Product RegistrationViewSonic Corporation ViewSonic ND4210w SETTING UP THE NETWORK DISPLAY INTRODUCTIONMANAGEMENT ContentsHELP ADMINISTRATIONACTIONS APPENDIX This page left blank for dual-sided printing PACKAGED CONTENTS OPTIONAL ACCESSORYINTRODUCTION REQUIREMENTSTWO MODES OF OPERATION STANDALONETAS MANAGED Ethernet cable Switch or Router PCFEATURES TWO MODES OF COMMUNICATIONFRONT VIEW POWER turns screen/ audio power offCH changes stream channel in development VOL + raises the volume VOL - lowers the volume MENU shows the IP address on the screenBACK VIEW RESET buttonREMOTE CONTROL POWER button On/Standby Show IP1. CONNECT TO A SWITCH OR ROUTER SETTING UP THE NETWORK DISPLAYConnect Multiple Network Displays optional Back view2. TURN POWER ON TO THE NETWORK DISPLAY Connect External Speakers optionalPower Button speaker3. PUT BATTERIES IN REMOTE CONTROL 4. LOGINSTARTUP URL/NETWORK CONFIGURATION MANAGEMENT4. If any changes were made to this screen, do the following BROWSER CONFIGURATION Page VNC CLIENT MANAGEMENT 1. Move the Brightness slider values range between -128 and TAS CONFIGURATION FTP SERVER SYSTEM SERVICES CONFIGURATION ACTIONS VIDEO UDP/RTP MULTICASTVIDEO HTTP VIDEO IPTV 1. Under Video, enter the IP Address and Port of the Video stream2. Under Audio, enter the IP Address and Port of the Audio stream 3. Click StartPress Start to start the video from the beginning VIDEO FILEPress Stop to end the video not Pause PLAYLIST To create a playlistVNC CLIENT ACTIONS OSD very transparent TRANSPARENCYOSD not transparent GO TO URL ADMINISTRATION ADVANCED VIDEO CONFIGURATIONSECURITY SAVE CONFIGURATION DEFAULT SETTINGS/RESET REBOOT FIRMWARE UPGRADE HELP STATUSLICENSE SERIAL NUMBER 2. In the Serial Number field, type the Serial Number click ApplyABOUT MANAGEMENT APPENDIXSCREENS ACTIONS ADMINISTRATION HELP CUSTOMER SUPPORT Country/RegionWebsite T = TelephoneMERCURY WARNING COMPLIANCE AND SAFETY NOTICESFCC CLASS A COMPLIANCE NOTICE UNITED STATES CANADIAN COMPLIANCE NOTICE GOST-R CERTIFICATIONEUROPEAN COMPLIANCE NOTICE For EU-member states only as followsCCC Class A Declaration FOR TAIWAN AND OTHER TRADITIONAL CHINESE MARKETSCHINA CCC MARK DECLARATION OF ROHS COMPLIANCE Important Safety Instructions CLEANING THE DEVICE DATA LOSS DISCLAIMERSPECIFICATIONS NetworkAudio CommunicationLIMITED WARRANTY

Related manuals

Manual 60 pages 7.69 Kb