ViewSonic ND4210w manual European Compliance Notice, For EU-member states only as follows

Page 53
EUROPEAN COMPLIANCE NOTICE

EUROPEAN COMPLIANCE NOTICE

Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms:

EN55022 (CISPR 22) Class A Radio Frequency Interference

EN55024 (IEC61000-4-2, -4-4, -4-5, -4-6, -4-11)

EN60950 (IEC950) Product Safety

WARNING This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

For EU-member states only as follows

The mark shown to the right is in compliance with the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE). The mark indicates the requirement NOT to dispose the equipment as unsorted municipal waste, but use the return and collection systems according to local law.

ViewSonic ND4210w

45

Downloaded From TV-Manual.com Manuals

Image 53
Contents Page This page left blank for dual-sided printing Product disposal at end of product life Product RegistrationViewSonic Corporation ViewSonic ND4210w INTRODUCTION SETTING UP THE NETWORK DISPLAYMANAGEMENT ContentsHELP ADMINISTRATIONACTIONS APPENDIX ViewSonic ND4210w OPTIONAL ACCESSORY PACKAGED CONTENTSINTRODUCTION REQUIREMENTSSTANDALONE TWO MODES OF OPERATIONTAS MANAGED Ethernet cable Switch or Router PCTWO MODES OF COMMUNICATION FEATURESPOWER turns screen/ audio power off FRONT VIEWCH changes stream channel in development VOL + raises the volume VOL - lowers the volume MENU shows the IP address on the screenRESET button BACK VIEWPOWER button On/Standby Show IP REMOTE CONTROLSETTING UP THE NETWORK DISPLAY 1. CONNECT TO A SWITCH OR ROUTERBack view Connect Multiple Network Displays optionalConnect External Speakers optional 2. TURN POWER ON TO THE NETWORK DISPLAYPower Button speaker4. LOGIN 3. PUT BATTERIES IN REMOTE CONTROLMANAGEMENT STARTUP URL/NETWORK CONFIGURATION4. If any changes were made to this screen, do the following BROWSER CONFIGURATION Page VNC CLIENT MANAGEMENT 1. Move the Brightness slider values range between -128 and TAS CONFIGURATION FTP SERVER SYSTEM SERVICES CONFIGURATION VIDEO UDP/RTP MULTICAST ACTIONSVIDEO HTTP 1. Under Video, enter the IP Address and Port of the Video stream VIDEO IPTV2. Under Audio, enter the IP Address and Port of the Audio stream 3. Click StartPress Start to start the video from the beginning VIDEO FILEPress Stop to end the video not Pause To create a playlist PLAYLISTVNC CLIENT ACTIONS OSD very transparent TRANSPARENCYOSD not transparent GO TO URL ADVANCED VIDEO CONFIGURATION ADMINISTRATIONSECURITY SAVE CONFIGURATION DEFAULT SETTINGS/RESET REBOOT FIRMWARE UPGRADE STATUS HELPLICENSE 2. In the Serial Number field, type the Serial Number click Apply SERIAL NUMBERABOUT MANAGEMENT APPENDIXSCREENS ACTIONS ADMINISTRATION HELP Country/Region CUSTOMER SUPPORT Website T = TelephoneMERCURY WARNING COMPLIANCE AND SAFETY NOTICESFCC CLASS A COMPLIANCE NOTICE UNITED STATES GOST-R CERTIFICATION CANADIAN COMPLIANCE NOTICEFor EU-member states only as follows EUROPEAN COMPLIANCE NOTICECCC Class A Declaration FOR TAIWAN AND OTHER TRADITIONAL CHINESE MARKETSCHINA CCC MARK DECLARATION OF ROHS COMPLIANCE Important Safety Instructions DATA LOSS DISCLAIMER CLEANING THE DEVICENetwork SPECIFICATIONSAudio CommunicationLIMITED WARRANTY
Related manuals
Manual 60 pages 7.69 Kb