BEFORE OPERATION
Remote Control Code Change and Operating Range
Code Change
This projector has eight different remote control codes (Code
1While pressing the MENU button, press the IMAGE button number of times corresponding to each remote control code number. Each time you press the IMAGE button, the code is changed sequentially. (See the list below.)
2To initialize the remote control code for the remote control, slide the RESET switch to the RESET, and then to the ON. The initial code is Code 1.
Remote Control Code | Number of Times of |
|
|
Pressing IMAGE |
|
| |
| Button |
| |
Code 1 | 1 | ▲ |
|
▲ |
| ||
|
| ZOOM |
|
Code 2 | 2 | ▲ |
|
|
|
| |
|
| FOCUS | MENU button |
Code 3 | 3 | ▲ | |
|
| ||
Code 4 | 4 |
|
|
Code 5 | 5 |
| SELECT |
|
| ||
Code 6 | 6 |
|
|
Code 7 | 7 |
|
|
Code 8 | 8 |
|
|
IMAGE button
RESET
Operating Range
Point Remote Control Unit toward projector (Receiver Window) whenever pressing any button . Maximum operating range for Remote Control Unit is about 16.4’ (5m) and 60° in front and rear of a projector.
60°
16.4’ (5 m)
16.4’ (5 m)
60°
Remote Control Batteries Installation
Remove battery
1compartment lid.
Press lid down- ward and slide it.
2 | Slide batteries into | 3 Replace compartment lid. |
compartment. |
Two AA size batteries For correct polarity (+ and
– ), be sure battery terminals are in contact with pins in compartment.
To insure safe operation, please observe following precautions :
●Use (2) AA, UM3 or R06 type alkaline batteries.
●Replace two batteries at same time.
●Do not use a new battery with an used battery.
●Avoid contact with water or liquid.
●Do not expose Remote Control Unit to moisture, or heat.
●Do not drop Remote Control Unit.
●If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.
●Danger of explosion if battery is incorrectly replaced.
●Dispose of used batteries according to the batteries manufacturers instructions and local rules.
19