Eiki LC-XG250L, LC-XG300L owner manual Remote control Display

Setting

Remote control

The eight different remote control codes (Code 1–Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).

The same code should set on both the projector and the remote control. For example, operating the projector in “Code 7”, the remote control code also must be switched to “Code 7”.

To change the code for the projector

Select a remote control code in this Setting Menu.

To change the code for the remote control:

Press and hold the MENU button and a number button (1–8) on the remote control for more than five seconds to switch between the codes. (See page 17 for details.)

RC sensor

Select a location of the infrared remote receiver of the remote control. See “Remote Control Operating Range” on page 18 for details.

Both	Activate both the front and back receiver.
Front	Activate only the front receiver.
Back	Activate only the back receiver.

Display

This function decides whether to display On-Screen Displays.

On	Show all the On-Screen displays. Use
	this function when you want to
	project images after the lamp
	becomes bright enough. The factory
	default setting is in this option.
Countdown Off	Show the input image instead of the
	countdown when turning on the
	projector. Use this function when you
	want to project the image as early as
	possible even when the lamp is not
	bright enough.
Off	Hide the On-Screen Displays except;
	●On-Screen Menu
	●“Power off?” (p.26)
	●“No signal” for Power management
	(p.58)
	●“Please wait ...”
	●White arrows for the True function
	in the Screen Menu (p.51)
	●“Filter warning” icon (red) (p.74)

Remote control

Display

Use the Point 78 buttons to switch between the options.

57