Eiki LC-XG250L, LC-XG300L owner manual Power management, On start

Setting

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not used for a certain period.

If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with “No signal” appears. It starts the countdown until the lamp is turned off. The countdown time can be set between 1–30 minutes. Use the Point 78 buttons to set the countdown timer.

Select one of the following options:

Ready	When the lamp has been fully cooled
	down, the POWER indicator changes to
	fast blinking. In this condition, the
	projection lamp can be turned on if the
	input signal is reconnected or any button
	on the top control or remote control is
	pressed.
Shut down	When the lamp has been fully cooled
	down, the power will be turned off.
Off	Power management function is off.

On start

When this function is set to “On,” the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.

✔Note:

•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 26). If the projector is turned off in the incorrect sequence, the On start function does not work properly.

Power management

Time left before the lamp is off.

Press the SELECT button at Power management and this dialog box appears. Use the Point 78 buttons to choose one of the three options. Press the Point d button to select the timer, and then use the Point 78 buttons to set timer.

58